Land Rover   ·   2015

Discovery Sport 2.2 SD4: Common faults & known problems

Common faults & known problems (2015)

11 known faults documented in workshop bulletins. Of these, three concern the brakes and two the electrical and ignition. Each entry covers the symptoms, cause, workshop fix and any part numbers.

11 documented faults

Engine & fuel system

1 documented fault — symptoms, causes and workshop fixes.

Warning message 'Restricted performance' displayed in instrument panel.

Fit new part1 part
Affects:

All models with 2.2 Diesel engine, 2014-16.

What you'd notice

Trouble code stored in engine control module (ECM) fault memory: P244A.

The repair

Diesel particulate filter (DPF) pressure sensor faulty.

Workshop instructions & parts1 part

Workshop procedure

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Fit new Diesel particulate filter (DPF) pressure sensor. Carry out Diesel particulate filter (DPF) pressure sensor calibration using diagnostic equipment.
Parts listed in the bulletin
PartPart numberQty
Diesel particulate filter (DPF) pressure sensorLR0713981

Data: Motorwise Workshop. Bulletin 2.

Electrical & ignition

2 documented faults — symptoms, causes and workshop fixes.

Amber Diesel particulate filter (DPF) warning lamp illuminated.

Affects:

All models with Diesel particulate filter (DPF).

Diesel particulate filter (DPF) blocked due to frequent short journeys or driving at constant low speeds. DPF regeneration process repeatedly not completed.

Workshop instructions

Workshop procedure

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Re-program engine control module (ECM) with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.
  3. Carry out DPF regeneration using suitable diagnostic equipment.

Data: Motorwise Workshop. Bulletin 7.

When vehicle is approached with keyless entry remote control, tailgate opens unintentionally.

Affects:

All models with tailgate automatic open/close function.

Tailgate control module wiring harness incorrectly routed.

Workshop instructions

Workshop procedure

  1. Locate tailgate control module behind LH rear wheel arch lining.
  2. Check tailgate control module wiring harness for correct routing.
  3. If tailgate control module wiring harness routing incorrect Fig.1267873.1 : Re-route tailgate control module wiring harness Fig.1267873.2 .
  4. Repeat procedure for opposite side.
  5. View View more information

Data: Motorwise Workshop. Bulletin 11.

Brakes

3 documented faults — symptoms, causes and workshop fixes.

Squeal from front brakes when braking lightly.

Fit modified part1 part
Affects:

All models fitted with 325 mm front brake discs, 2015→.

Vibration between brake pads and discs.

Workshop instructions & parts1 part

Workshop procedure

  1. Fit modified front brake pads.
Parts listed in the bulletin
PartPart numberQty
Front brake padsLR0942361

Data: Motorwise Workshop. Bulletin 1.

Irregular operation of stop-start system. Engine does not restart when neutral selected.

Affects:

All models with 2.2 Diesel engine, →2015.

ABS/ESP control module software fault.

Workshop instructions

Workshop procedure

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Re-program ABS/ESP control module with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.

Data: Motorwise Workshop. Bulletin 6.

Loss of drive after stop-start system operation.

Affects:

All models with stop-start system and ZF 9HP48 transmission code.

What you'd notice

Transmission gear position indicator flashes. Warning message 'Reselect gear to manoeuvre' displayed in instrument panel.

The repair

ABS/ESP control module incorrectly programmed.

Workshop instructions

Workshop procedure

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Re-program ABS/ESP control module with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.

Data: Motorwise Workshop. Bulletin 9.

Suspension & drivetrain

2 documented faults — symptoms, causes and workshop fixes.

Knocking noise from front suspension when driving over rough roads or speed humps.

1 part
Affects:

All models, 2015-16.

Front shock absorber protective cap adrift.

Workshop instructions & parts1 part

Workshop procedure

  1. Lift up shock absorber damper rod cover to gain access to shock absorber protective cap.
  2. Thoroughly clean area indicated Fig.1228567.1 .
  3. Apply adhesive to area indicated Fig.1228567.1 .
  4. Fit shock absorber protective cap into position.
  5. DO NOT move vehicle for 6 hours to allow adhesive to cure.
  6. Repeat procedure for opposite side, if necessary.
  7. View View more information
Parts listed in the bulletin
PartPart numberQty
AdhesiveLR0882851

Data: Motorwise Workshop. Bulletin 5.

Noise from front suspension when driving over rough roads or speed humps.

1 part
Affects:

All models.

Front anti-roll bar making contact with wheel arch lining.

Workshop instructions & parts1 part

Workshop procedure

  1. Inspect wheel arch lining for signs of contact with front anti-roll bar.
  2. If contact has occurred: Remove wheel arch lining and discard retaining nuts Fig.1266488.1 . Elongate wheel arch lining hole to make a 7 mm slot Fig.1266488.2 . Modify wheel arch lining by cutting off area indicated Fig.1266488.3 . Fit wheel arch lining using new retaining nuts Fig.1266488.1 . Ensure wheel arch lining is pushed up as far as possible. Caution: All models with active height control suspension. Ensure suspension ride height sensor securing clip positioned in correct hole . Repeat procedure for opposite side.
  3. View View more information
Parts listed in the bulletin
PartPart numberQty
Wheel arch lining retaining nutRYH5007804

Data: Motorwise Workshop. Bulletin 10.

Clutch & gearbox

2 documented faults — symptoms, causes and workshop fixes.

Oil leak from transmission.

Fit modified part3 parts
Affects:

All models with transmission code 9HP48, 2014→.

What you'd notice

Abnormal noise from transmission. Poor gear shifting.

The repair

Poor manufacture of transmission oil gallery plate gasket.

Workshop instructions & parts3 parts

Workshop procedure

  1. Remove and discard transmission oil gallery plate gasket and retaining bolts.
  2. Thoroughly clean all mating surfaces.
  3. Fit modified transmission oil gallery plate gasket.
  4. Refit transmission oil gallery plate using new retaining bolts. Tightening torque: 10 Nm. Observe correct transmission oil gallery plate retaining bolt tightening sequence Fig.1217801 .
  5. Top up transmission oil as required.
Parts listed in the bulletin
PartPart numberQty
Retaining boltRefer to manufacturer11
Transmission oil gallery plate gasketLR0864131
Transmission oilLR023288As required

Data: Motorwise Workshop. Bulletin 4.

Warning message 'transmission fault' displayed in instrument panel.

Fault codesP0933P0936Fit new part4 parts
Affects:

All models with automatic transmission (AT).

What you'd notice

Trouble codes stored in transmission control module (TCM) fault memory: P0933, P0936.

The repair

Wiring harness in the transmission not correctly crimped.

Workshop instructions & parts4 parts

Workshop procedure

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Fit new transmission valve block wiring harness.
  3. Re-program transmission control module (TCM) with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.
Parts listed in the bulletin
PartPart numberQty
Transmission valve block wiring harness (petrol)LR0498881
Transmission valve block wiring harness (Diesel)LR0647901
Transmission oilLR0232882
Transmission service kitLR0498761

Data: Motorwise Workshop. Bulletin 8.

Wipers & visibility

1 documented fault — symptoms, causes and workshop fixes.

Windscreen wipers intermittent operation or not working.

1 part
Affects:

All models, 2012→.

What you'd notice

Indicators intermittent operation or not working.

The repair

Poor electrical connection between switch assembly and harness multi-plug.

Workshop instructions & parts1 part

Workshop procedure

  1. Remove windscreen wiper switch.
  2. Clean windscreen wiper switch harness multi-plug terminals Fig.1217605.1 .
  3. Lightly coat terminals with grease Fig.1217605.1 . Use specified grease.
  4. Refit windscreen wiper switch.
  5. Repeat procedure for indicator switch.
Parts listed in the bulletin
PartPart numberQty
Electrical contact grease (Nyogel)LR0546141

Data: Motorwise Workshop. Bulletin 3.

Take it with you

Before you view one

Each documented fault as a quick check for a viewing or test drive — tick them off as you go.

  • 01 ↗
  • 02 ↗
  • 03 ↗
  • 04 ↗
  • 05 ↗
  • 06 ↗
  • 07 ↗
  • 08 ↗
  • 09 ↗
  • 10 ↗
  • 11 ↗

A little workshop vocabulary

Workshop terms used on this page

Definitions for the technical language used in these bulletins.

ECM
Engine control module — the car's engine computer
Nm
Newton-metres — the standard unit for how tightly a bolt is done up
DPF
Diesel particulate filter — traps soot in the exhaust and burns it off periodically
Trouble Codes
Standardised fault codes stored by the engine computer, read with a diagnostic tool
ABS/ESP
Anti-lock braking and electronic stability programme — the computer that stops the wheels locking and keeps the car stable
LH
Left-hand — the left side of the vehicle as you sit in it
TCM
Transmission control module — the gearbox computer
Anti-Roll Bar
A bar that links the left and right suspension to cut body roll in corners
Control Module
A computer that runs one of the car's systems (engine, gearbox, brakes, body, and so on)
DPF Regeneration
The process that burns soot out of the diesel particulate filter, usually on a longer run
Fault Memory
The list of stored trouble codes in a control module
Instrument Panel
The dashboard display that shows warning lights and messages
Multi-Plug
A multi-pin electrical connector on a wiring harness
Re-Program
Update the software on a control module using the manufacturer's diagnostic tool
Ride Height
How high the vehicle sits; on air suspension this can be raised or lowered
Stop-Start
The system that cuts the engine at idle and restarts it when you pull away
Trouble Code
A standardised fault code stored by a control module, read with a diagnostic tool
Valve Block
The set of solenoid valves that directs air or fluid in the air-suspension or gearbox
Wiring Harness
The bundled cables that carry power and signals around the vehicle
Calibration
Setting a sensor or module so its readings match the real world

Common questions

Using this guide.

What are the common faults with the Land Rover Discovery Sport 2.2 SD4?

Garages and workshops regularly encounter 11 documented faults on the Land Rover Discovery Sport 2.2 SD4 — three concern the brakes and two the electrical and ignition. Each fault above lists the symptoms, cause, fix and any parts needed.

Does every Land Rover Discovery Sport 2.2 SD4 have these faults?

No. These are patterns documented across the model by workshops, not predictions for an individual car. Where a fault applies only to certain vehicles or VIN ranges, that is listed with the fault.

Can I check for Land Rover Discovery Sport 2.2 SD4 faults when viewing one?

Many of them, yes — the documented symptoms are things you can see, hear or feel on a viewing or test drive. The 'Before you view one' checklist above turns each documented fault into a quick check you can tick off as you go.

Workshop term

See in the glossary →