Engine & identification
Vehicle identification
| No. of cylinders Type | 4/OHC |
|---|---|
| Capacity (Fiscal) cc | 1586 (1575) |
| Compression ratio :1 | 8,6 |
| Suitable for unleaded petrol | Yes |
| Minimum octane rating RON | 91 |
| Ignition system Type | SZ |
Ignition system
| Ballast resistance Ohm | 1,6 |
|---|---|
| Primary resistance Ohm | 1,5 |
| Contact breaker gap/trigger air gap mm | 0,5 |
| Dwell angle °(%) | 49-55 (54-61) |
Firing order
The firing order for the Mazda B Series 1.6 (1974–1981) is 1-3-4-2.
| Firing order | 1-3-4-2 |
|---|
Valve clearances
Valve clearances for the Mazda B Series 1.6 (1974–1981) are 0,30 mm inlet and 0,30 mm exhaust, measured hot.
| Valve clearance - INLET mm | 0,30 hot |
|---|---|
| Valve clearance - EXHAUST mm | 0,30 hot |
Engine oil & fluids
Engine oil
The Mazda B Series 1.6 (1974–1981) takes 4.1 litres of engine oil with the filter.
Manual gearbox
The manual gearbox has a listed capacity of 1.5 litres.
Coolant
The listed total cooling-system capacity is 6.4 litres.
Grades, filling conditions and capacities
| Engine oil options | |
|---|---|
| Engine with filter(s) litres | 4.1 |
| Other lubricants and capacities | |
| Manual transmission litres | 1.5 |
| Differential rear litres | 1.3 |
| Cooling system - total capacity litres | 6.4 |
Service & electrical
Ignition timing
Basic ignition timing for the Mazda B Series 1.6 (1974–1981) is 8°±1° BTDC at 800 rpm.
| Ignition timing - basic BTDC °Engine/rpm | 8±1/800 |
|---|
Battery
The Mazda B Series 1.6 (1974–1981) uses a 12 V, 60 Ah battery.
| Battery V/RC(Ah) | 12 (60) |
|---|
Spark plugs
The Mazda B Series 1.6 (1974–1981) uses NGK BPR5ES spark plugs with a 0,8 mm electrode gap.
| Spark plugs Original equipment | NGK |
|---|---|
| Spark plug Type | BPR5ES |
| Electrode gap mm | 0,8 |
| Spark plugs Make | Bosch |
| Spark plug Type | WR7DC |
| Electrode gap mm | 0,8 |
| Spark plugs Make | Champion |
| Spark plug Type | RN9YCC |
| Electrode gap mm | 0,8 |
| Spark plugs Make | NGK |
| Spark plug Type | BPR5ES |
| Electrode gap mm | 0,8 |
Tuning and emissions
| Ignition advance checks °Engine/rpm | 0/550 |
|---|---|
| Ignition advance checks °Engine/rpm | 22/4000 |
| Vacuum check | Ignition timing advances |
| Vacuum range °Engine | 17 |
| Vacuum starts mbar | 215 |
| Vacuum ends mbar | 345 |
| Idle speed rpm | 700-750 |
| Oil temperature °C | 60 |
| CO level at idle speed - tailpipe Vol. % CO | 2,0-3,0 |
| HC level at idle speed ppm | 500 |
Starting and charging
| Minimum starting voltage V | 11,5 |
|---|---|
| Regulated voltage V | 14,0-15,5 |
Service checks and adjustments
| Compression pressure bar | 8,3-8,4 |
|---|---|
| Oil pressure bar/rpm | 3,5-4,5 |
| Radiator cap bar | 0,90 |
| Thermostat opens °C | 82 |
| Drive belt tension - alternator/PAS/AC mm | 12-14 |
Fuel system
| Fuel pump delivery pressure bar | 0,20-0,25 |
|---|
Tightening torques
Cylinder head bolt torque
The cylinder head bolt torque for the Mazda B Series 1.6 (1974–1981) is 95-100 Nm.
| Cylinder head | |
|---|---|
| Tighten | 95-100 Nm |
| Other engine tightening torques | |
|---|---|
| Main bearings Stage 1 | 42-45 Nm |
| Main bearings Stage 2 | 84-90 Nm |
| Big end bearings Stage 1 | 25-26 Nm |
| Big end bearings Stage 2 | 50-55 Nm |
| Flywheel/driveplate | 155-163 Nm |
| Spark plugs | 15-21 Nm |
| Chassis tightening torques | |
| Road wheels | 80-90 Nm |
Frequently asked questions
What is the firing order of the Mazda B Series 1.6?
The firing order for the Mazda B Series 1.6 (1974–1981) is 1-3-4-2.
What spark plugs does the Mazda B Series 1.6 use?
The Mazda B Series 1.6 (1974–1981) uses NGK BPR5ES spark plugs with a 0,8 mm electrode gap.
How much oil does the Mazda B Series 1.6 take?
The Mazda B Series 1.6 (1974–1981) takes 4.1 litres of engine oil with the filter.
What are the valve clearances for the Mazda B Series 1.6?
Valve clearances for the Mazda B Series 1.6 (1974–1981) are 0,30 mm inlet and 0,30 mm exhaust, measured hot.
What is the cylinder head torque for the Mazda B Series 1.6?
The cylinder head bolt torque for the Mazda B Series 1.6 (1974–1981) is 95-100 Nm.
What is the ignition timing for the Mazda B Series 1.6?
Basic ignition timing for the Mazda B Series 1.6 (1974–1981) is 8°±1° BTDC at 800 rpm.