Engine & identification
Vehicle identification
| No. of cylinders Type | 4/DOHC |
|---|---|
| Capacity cc | 1951 |
| Compression ratio :1 | 19,1 |
Injection system
| Air metering Type | Mass |
|---|---|
| Fuel/injection pump assembly Make | Bosch |
| Fuel/injection pump assembly Type | CP1 |
| Pump type | Common rail |
| Fuel feed/lift pump delivery pressure bar | 2,5 |
| Injector nozzle Make | Bosch |
| Nozzle and holder assembly Part No. | CR10445110030 |
| Nozzle opening pressure - new/used bar | 250 |
| Engine coolant temperature (ECT) sensor Ohm/°C | 950/100 |
Injection sequence
The injection sequence for the Land Rover Freelander 2.0 Td4 (2000–2006) is 1-3-4-2.
| Injection sequence | 1-3-4-2 |
|---|
Valve clearances
Valve clearances on the Land Rover Freelander 2.0 Td4 (2000–2006) are hydraulic — they self-adjust, so no manual clearance figure applies.
| Valve clearance - INLET mm | Hydraulic |
|---|---|
| Valve clearance - EXHAUST mm | Hydraulic |
Engine oil & fluids
Engine oil
The Land Rover Freelander 2.0 Td4 (2000–2006) takes 6.8 litres of engine oil with the filter.
A listed engine oil option is SAE 5W-30 for cold climates, with API/ACEA classification CF/B3.
A listed engine oil option is SAE 5W-40 for moderate climates, with API/ACEA classification CF/B3.
A listed engine oil option is SAE 15W-40 as an alternative for moderate climates, with API/ACEA classification CF/B3.
A listed engine oil option is SAE 10W-40 for hot climates, with API/ACEA classification CF/B3.
Manual gearbox
The manual gearbox has a listed capacity of 1.6 litres. The specified oil is Texaco MTF 94.
Transfer box
The transfer box has a listed capacity of 1.1 litres. The specified oil is SAE 75W-90, with classification GL-5.
Coolant
The listed total cooling-system capacity is 7.3 litres.
Grades, filling conditions and capacities
| Engine oil options | |
|---|---|
| Ambient temperature range | Cold climate |
| Engine oil grade SAE | 5W-30 |
| Engine oil classification API/ACEA | CF/B3 |
| Ambient temperature range | Moderate climate |
| Engine oil grade SAE | 5W-40 |
| Engine oil classification API/ACEA | CF/B3 |
| Ambient temperature range | Moderate climate alternative |
| Engine oil grade SAE | 15W-40 |
| Engine oil classification API/ACEA | CF/B3 |
| Ambient temperature range | Hot climate |
| Engine oil grade SAE | 10W-40 |
| Engine oil classification API/ACEA | CF/B3 |
| Engine with filter(s) litres | 6.8 |
| Other lubricants and capacities | |
| Manual transmission oil grade SAE | Texaco MTF 94 |
| Manual transmission litres | 1.6 |
| Automatic transmission fluid Type | Texaco N402 |
| Automatic transmission (drain & refill) litres | 4.0 |
| Automatic transmission (dry fill) litres | 8.5 |
| Differential oil grade - rear SAE | 80W-90 |
| Differential oil classification - rear | GL-5 |
| Differential rear litres | 0.8 |
| Transfer box oil grade SAE | 75W-90 |
| Transfer box oil classification | GL-5 |
| Transfer box litres | 1.1 |
| Cooling system - total capacity litres | 7.3 |
| Brake fluid Type | DOT 4 |
| Power steering fluid Type | Dexron II/III |
Brakes & wear limits
Brake disc thickness
Brake discs on the Land Rover Freelander 2.0 Td4 (2000–2006) are replaced at a minimum thickness of 18 mm (ventilated) front; the rear brake drums are replaced at a maximum diameter of 255,5 mm.
| Minimum disc thickness for replacement - ventilated Front | 18 mm |
|---|---|
| Maximum drum diameter for replacement Rear | 255,5 mm |
Brake disc and drum dimensions
| Disc runout Front | 0,04 mm |
|---|---|
| Minimum pad thickness Front | 3 mm |
| Minimum shoe thickness Rear | 2 mm |
| Parking brake travel No. of notches | 4-7 |
Service & electrical
Battery
The Land Rover Freelander 2.0 Td4 (2000–2006) uses a 12 V, 75 Ah battery (reserve capacity 130 minutes).
| Battery V/RC(Ah) | 12/130 (75) |
|---|
Tuning and emissions
| Idle speed rpm | 780±50 |
|---|---|
| Oil temperature °C | 70 |
| Water temperature °C | 85 |
| Maximum time at governed speed secs | 2,0 |
| Test mode A/B | B |
| Probe type 1/2 | 1 |
| Smoke opacity - EU limit m-1 (%) | 3,00 (73) |
Starting and charging
| Maximum cranking amps A | 203-248 |
|---|---|
| Alternator output A/V/rpm | 105/12 |
Service checks and adjustments
| Oil pressure bar/rpm | 3,0-4,5/3500 |
|---|---|
| Radiator cap bar | 1,00 |
| Thermostat opens °C | 88 |
Tightening torques
| Cylinder head instructions | — |
|---|---|
| Cylinder head | |
| Renew bolts | Yes |
| Other engine tightening torques | |
| Main bearings Renew bolts/nuts | Yes |
| Main bearings Stage 1 | 20 Nm |
| Main bearings Stage 2 | 70 Nm |
| Big end bearings Renew bolts/nuts | Yes |
| Big end bearings Stage 1 | — |
| Oil pump to cylinder block | 25 Nm |
| Sump bolts | 28 Nm M6=10 Nm |
| Sump drain bolt | 28 Nm |
| Flywheel/driveplate | 115 Nm |
| Clutch pressure plate | 25 Nm |
| Crankshaft pulley/damper centre bolt | — |
| Camshaft sprocket/gear | 20 Nm+35° |
| Camshaft carrier/cap | 10 Nm |
| Camshaft/rocker cover | 10 Nm |
| Inlet manifold to cylinder head | 15 Nm M6=10 Nm |
| Exhaust manifold to cylinder head | 24 Nm |
| Exhaust downpipe to manifold | 50 Nm |
| Water pump | 10 Nm |
| Injector/clamp | 10 Nm |
| Injector pipe unions | 20 Nm |
| Fuel/injection pump sprocket/gear | 65 Nm |
| Fuel/injection pump flange | 24 Nm |
| Fuel/injection pump mounting | 24 Nm |
| Glow plugs | 20 Nm |
| Crankshaft position (CKP) sensor/engine speed (RPM) sensor | 8 Nm |
| Camshaft position (CMP) sensor | 8 Nm |
| Engine coolant temperature (ECT) sensor | 15 Nm |
| Engine oil pressure switch | 38 Nm |
| Oil filter | 25 Nm |
| Engine upper cover | 8 Nm |
| Chassis tightening torques | |
| Front hub | 400 Nm |
| Rear hub | 400 Nm |
| Steering wheel | 45 Nm |
| Steering rack/box mounting | 45 Nm |
| Steering track rod end | 55 Nm |
| Brake disc to hub Front | 5 Nm |
| Brake caliper to carrier Front | 27 Nm |
| Brake caliper/carrier to hub Front | 100 Nm |
| Back plate to hub Rear | 45 Nm |
| Road wheels | 115 Nm |
Air conditioning
| No. of AC service connectors | 2 |
|---|---|
| Air conditioning restrictor type | Expansion valve |
| Compressor clutch/magnetic coupling | Yes |
| Compressor variable displacement solenoid | No |
| Air conditioning refrigerant Type | R134a |
| Air conditioning refrigerant quantity grams | 540±25 |
| Air conditioning oil group | PAG |
| Air conditioning oil Type | Dens Oil 8 |
| Air conditioning oil viscosity ISO | 46 |
Frequently asked questions
What is the injection sequence of the Land Rover Freelander 2.0 Td4?
The injection sequence for the Land Rover Freelander 2.0 Td4 (2000–2006) is 1-3-4-2.
How much oil does the Land Rover Freelander 2.0 Td4 take?
The Land Rover Freelander 2.0 Td4 (2000–2006) takes 6.8 litres of engine oil with the filter. A listed engine oil option is SAE 5W-30 for cold climates, with API/ACEA classification CF/B3. A listed engine oil option is SAE 5W-40 for moderate climates, with API/ACEA classification CF/B3. A listed engine oil option is SAE 15W-40 as an alternative for moderate climates, with API/ACEA classification CF/B3. A listed engine oil option is SAE 10W-40 for hot climates, with API/ACEA classification CF/B3.
What are the valve clearances for the Land Rover Freelander 2.0 Td4?
Valve clearances on the Land Rover Freelander 2.0 Td4 (2000–2006) are hydraulic — they self-adjust, so no manual clearance figure applies.
What is the minimum brake disc thickness for the Land Rover Freelander 2.0 Td4?
Brake discs on the Land Rover Freelander 2.0 Td4 (2000–2006) are replaced at a minimum thickness of 18 mm (ventilated) front; the rear brake drums are replaced at a maximum diameter of 255,5 mm.
What battery does the Land Rover Freelander 2.0 Td4 use?
The Land Rover Freelander 2.0 Td4 (2000–2006) uses a 12 V, 75 Ah battery (reserve capacity 130 minutes).