Engine & identification
Vehicle identification
| No. of cylinders Type | 6/DOHC |
|---|---|
| Capacity cc | 2993 |
| Compression ratio :1 | 16,1 |
| Fuel system Make | Bosch |
| Fuel system Type | EDC 17CP |
Injection system
| Air metering Type | Mass/MAP |
|---|---|
| Pump type | Common rail |
| Fuel main pump delivery pressure bar | 1650 |
| Fuel feed/lift pump delivery pressure bar | 0,5 |
Injection sequence
The injection sequence for the Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) is 1-4-2-5-3-6.
| Injection sequence | 1-4-2-5-3-6 |
|---|
Valve clearances
Valve clearances on the Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) are hydraulic — they self-adjust, so no manual clearance figure applies.
| Valve clearance - INLET mm | Hydraulic |
|---|---|
| Valve clearance - EXHAUST mm | Hydraulic |
Engine oil & fluids
Engine oil
The Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) takes 5.9 litres of engine oil with the filter. The specified engine oil grade is SAE 5W-30 synthetic for all ambient temperatures, with oil specification STJLR.03.5005.
Transfer box
The transfer box has a listed capacity of 1.5 litres. The specified oil is Shell TF 0753 Synthetic.
Coolant
The listed coolant type is Havoline Extended Life. The recorded coolant colour is Orange. The listed total cooling-system capacity is 15.9 litres.
Grades, filling conditions and capacities
| Engine oil options | |
|---|---|
| Ambient temperature range | All temperatures |
| Engine oil grade SAE | 5W-30 Synthetic |
| Engine oil classification OEM | STJLR.03.5005 |
| Engine with filter(s) litres | 5.9 |
| View more information | — |
| Other lubricants and capacities | |
| Automatic transmission fluid Type | Shell L12108 (ZF Lifeguard 8) |
| Automatic transmission (dry fill) litres | 9.9 |
| Differential oil grade - front SAE | Castrol SAF-XO Synthetic |
| Differential front/AT litres | 0.6 |
| Differential oil grade - rear SAE | Castrol SAF-XO Synthetic |
| Differential rear litres | 1.1 |
| Transfer box oil grade SAE | Shell TF 0753 Synthetic |
| Transfer box litres | 1.5 |
| Coolant Type | Havoline Extended Life |
| Coolant Colour | Orange |
| Cooling system - total capacity litres | 15.9 |
| Brake fluid Type | DOT 4 |
| Power steering fluid Type | Texaco PSF 33270 |
| Power steering fluid litres | 1.2 |
Brakes & wear limits
Brake disc thickness
Brake discs on the Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) are replaced at a minimum thickness of 27 mm (ventilated) front and 18 mm rear.
| Minimum disc thickness for replacement - ventilated Front | 27 mm |
|---|---|
| Minimum disc thickness for replacement Rear | 18 mm |
Brake disc and drum dimensions
| Disc thickness variation Front | 0,010 mm |
|---|---|
| Disc thickness variation Rear | 0,010 mm |
| Disc runout Front | 0,05 mm |
| Disc runout Rear | 0,09 mm |
| Minimum pad thickness Front | 3 mm |
| Minimum pad thickness Rear | 3 mm |
| Minimum shoe thickness Rear | 2 mm |
Bar lengths use a square-root scale so small and large values stay readable.
Service & electrical
Tuning and emissions
| Idle speed rpm | 650±150 |
|---|---|
| Rated no load speed rpm | 4650-4850 |
| Oil temperature °C | 80 |
| Idle speed - for smoke test rpm | 500-800 |
| Governed speed range - for smoke test rpm | 4650-4850 |
| Maximum time at governed speed secs | 2,0 |
| Test mode A/B | B |
| Probe type 1/2 | 1 |
| Smoke opacity - EU limit m-1 (%) | 1,50 (48) |
| Smoke opacity - homologation value m-1 (%) | 0,51 (19) |
Starting and charging
| Battery V/RC(Ah) | 12 |
|---|
Service checks and adjustments
| Radiator cap bar | 1,10 |
|---|---|
| Thermostat opens °C | 88 |
Tightening torques
Cylinder head bolt torque
The cylinder head bolts on the Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) are tightened in 5 stages: 20 Nm, then 40 Nm, then 80 Nm, then 90°, then a final 90°.
| Cylinder head | |
|---|---|
| Renew bolts | Yes |
| Tighten | 20 Nm |
| Tighten | 40 Nm |
| Tighten | 80 Nm |
| Tighten | 90° |
| Tighten | 90° |
| Cylinder head instructions | — | |
|---|---|---|
| Other engine tightening torques | ||
| Oil pump to cylinder block | 10 Nm | |
| Sump bolts | 10 Nm M8=23 Nm | |
| Sump drain bolt | 23 Nm | |
| Flywheel/driveplate | 50 Nm+45°+45° | |
| Crankshaft pulley/damper centre bolt | — | |
| Crankshaft pulley/damper bolts | 25 Nm | |
| Camshaft sprocket/gear | — | |
| View more information | — | |
| Camshaft carrier/cap | — | |
| Camshaft/rocker cover | 10 Nm | |
| Inlet manifold to cylinder head | 9 Nm | |
| Exhaust manifold to cylinder head | 28 Nm | |
| Exhaust downpipe to manifold | 28 Nm | |
| Water pump | 10 Nm | |
| Injector/clamp | 9 Nm | |
| Injector pipe unions | 1)15 Nm 2)35 Nm | |
| Fuel/injection pump sprocket/gear | 50 Nm | |
| Fuel/injection pump mounting | 23 Nm | |
| Glow plugs | 10 Nm | |
| Crankshaft position (CKP) sensor/engine speed (RPM) sensor | 5 Nm | |
| Camshaft position (CMP) sensor | 10 Nm | |
| Nitrogen oxide (NOx) sensor | 35 Nm | |
| Engine oil pressure switch | 14 Nm | |
| Oil filter | 28 Nm | |
| Chassis tightening torques | ||
| Front hub | 230 Nm | |
| Front hub - wheel bearing housing bolts | 115 Nm | |
| Rear hub | 420 Nm | |
| Steering wheel | 63 Nm | |
| Steering rack/box mounting | 175 Nm | |
| Steering track rod end | 76 Nm M14=150 Nm | |
| Brake disc to hub Front | 35 Nm | |
| Brake caliper to carrier Front | 35 Nm | |
| Brake caliper/carrier to hub Front | 275 Nm | |
| Brake disc to hub Rear | 35 Nm | |
| Brake caliper to carrier Rear | 35 Nm | |
| Brake caliper/carrier to hub Rear | 115 Nm | |
| ABS sensor Front | 9 Nm | |
| ABS sensor Rear | 9 Nm | |
| Road wheels | 1)70 Nm 2)140 Nm | |
Bar lengths use a square-root scale so small and large values stay readable.
Air conditioning
| No. of AC service connectors | 2 |
|---|---|
| Air conditioning restrictor type | Expansion valve |
| Compressor clutch/magnetic coupling | No |
| Compressor variable displacement solenoid | Yes |
| Air conditioning refrigerant Type | R134a |
| Air conditioning refrigerant quantity grams | 600 |
| Air conditioning oil Type | SPA2 |
| Air conditioning oil quantity cm³ | 80 |
Frequently asked questions
What is the injection sequence of the Land Rover Discovery 4 Discovery 3 SDV6?
The injection sequence for the Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) is 1-4-2-5-3-6.
How much oil does the Land Rover Discovery 4 Discovery 3 SDV6 take?
The Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) takes 5.9 litres of engine oil with the filter. The specified engine oil grade is SAE 5W-30 synthetic for all ambient temperatures, with oil specification STJLR.03.5005.
What are the valve clearances for the Land Rover Discovery 4 Discovery 3 SDV6?
Valve clearances on the Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) are hydraulic — they self-adjust, so no manual clearance figure applies.
What is the cylinder head torque for the Land Rover Discovery 4 Discovery 3 SDV6?
The cylinder head bolts on the Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) are tightened in 5 stages: 20 Nm, then 40 Nm, then 80 Nm, then 90°, then a final 90°.
What is the minimum brake disc thickness for the Land Rover Discovery 4 Discovery 3 SDV6?
Brake discs on the Land Rover Discovery 4 Discovery 3 SDV6 (2011–2012) are replaced at a minimum thickness of 27 mm (ventilated) front and 18 mm rear.