Engine & identification
Vehicle identification
| No. of cylinders Type | 8/DOHC |
|---|---|
| Capacity (Fiscal) cc | 4664 |
| Compression ratio :1 | 10,0 |
| Suitable for unleaded petrol | Yes |
| Minimum octane rating RON | 95 |
| Ignition system Make | Toyota |
| Ignition system Type | TCCS |
| Ignition system Description | Map-DI |
| Trigger location | Cam/Crankshaft |
| Fuel system Make | Toyota |
| Fuel system Type | TCCS |
| Fuel system Description | MFI-s |
| Air metering Type | Mass |
| Combined ignition and fuel ECM | Yes |
| Diagnostic socket | Yes |
Ignition system
| Ignition coil supply voltage + with ballast V | 12,0 |
|---|
Firing order
The firing order for the Toyota Landcruiser 4.7 V8 (2008–2012) is 1-8-4-3-6-5-7-2.
| Firing order | 1-8-4-3-6-5-7-2 |
|---|
Valve clearances
Valve clearances for the Toyota Landcruiser 4.7 V8 (2008–2012) are 0,15-0,25 mm inlet and 0,25-0,35 mm exhaust, measured cold.
| Valve clearance - INLET mm | 0,15-0,25 cold |
|---|---|
| Valve clearance - EXHAUST mm | 0,25-0,35 cold |
Engine oil & fluids
Engine oil
The Toyota Landcruiser 4.7 V8 (2008–2012) takes 6.2 litres of engine oil with the filter.
See the reference table for the complete engine oil entries and their conditions.
Transfer box
See the reference table for the complete transfer box entries and their conditions.
Coolant
The listed total cooling-system capacity is 14.0 litres.
See the reference table for the complete coolant entries and their conditions.
Grades, filling conditions and capacities
| Preferred engine oil | |
|---|---|
| Ambient temperature range | All temperatures |
| Engine oil grade SAE | 5W-30 |
| Engine oil classification API/ACEA | SL/A3 |
| Engine oil options | |
| Ambient temperature range | -18°C➞ |
| Engine oil grade SAE | 10W-30 |
| Engine oil classification API/ACEA | SL/A3 |
| Ambient temperature range | -12°C➞ |
| Engine oil grade SAE | 15W-40 |
| Engine oil classification API/ACEA | SL/A3 |
| Ambient temperature range | -7°C➞ |
| Engine oil grade SAE | 20W-50 |
| Engine oil classification API/ACEA | SL/A3 |
| Engine with filter(s) litres | 6.2 |
| Other lubricants and capacities | |
| Automatic transmission fluid Type | Toyota ATF WS |
| Automatic transmission (drain & refill) litres | — |
| View more information | — |
| If 'D' shift indicator flashes, switch ignition OFF. Allow ATF to cool, then repeat above procedure. | |
| Automatic transmission (dry fill) litres | — |
| Automatic transmission fluid | |
| Differential oil grade - front SAE | Toyota LT 75W-85 |
| Differential oil classification - front | GL-5 |
| Differential front/AT litres | 1.9 |
| Differential oil grade - rear SAE | Toyota LT 75W-85 LSD=LX 75W-85 |
| Differential oil classification - rear | GL-5 |
| Differential rear litres | 4,15-4,25 LSD=4,1-4,2 |
| Transfer box oil grade SAE | Toyota LF 75W |
| Transfer box litres | 1.4-1.5 |
| Coolant Type | Toyota SLLC |
| Coolant Colour | Pink |
| Cooling system - total capacity litres | 14.0 |
| Cooling system | |
| Brake fluid Type | DOT 3 |
| Power steering fluid Type | Dexron II/III |
| Power steering fluid litres | 1.0 |
Brakes & wear limits
Brake disc thickness
Brake discs on the Toyota Landcruiser 4.7 V8 (2008–2012) are replaced at a minimum thickness of 29 mm (ventilated) front and 16 mm rear.
| Minimum disc thickness for replacement - ventilated Front | 29 mm |
|---|---|
| Minimum disc thickness for replacement Rear | 16 mm |
| Maximum drum diameter for replacement Rear | 241 mm |
Brake disc and drum dimensions
| Disc runout Front | 0,05 mm |
|---|---|
| Disc runout Rear | 0,15 mm |
| Minimum pad thickness Front | 1 mm |
| Minimum pad thickness Rear | 1 mm |
| Minimum shoe thickness Rear | 1 mm |
| Parking brake travel No. of notches | 5-7 |
Service & electrical
Spark plugs
The Toyota Landcruiser 4.7 V8 (2008–2012) uses Denso SK20R11 spark plugs with a 1,1 mm electrode gap.
| Spark plugs Original equipment | Denso |
|---|---|
| Spark plug Type | SK20R11 |
| Electrode gap mm | 1,1 |
| Spark plugs Make | NGK |
| Spark plug Type | IFR6A11 |
| Electrode gap mm | 1,1 |
Tuning and emissions
| Tuning conditions | — |
|---|---|
| View more information | — |
| Ignition timing | |
| Ignition timing - basic BTDC °Engine/rpm | 10±5/700 Not adjustable |
| Ignition advance checks °Engine/rpm | ECM Controlled |
| Idle speed rpm | 700±50 Not adjustable |
| Oil temperature °C | 80 |
| CO level at idle speed - tailpipe Vol. % CO | 0,2 Max Not adjustable |
| HC level at idle speed ppm | 100 |
| CO2 level at idle speed Vol. % CO2 | 14,5-16 |
| O2 level at idle speed Vol. % O2 | 0,1-0,5 |
| Increased idle speed for CO test rpm | 2400-2600 |
| CO content at increased idle speed Vol. % | 0,3 |
| Lambda at increased idle λ | 0,98-1,02 |
Starting and charging
| Battery V/RC(Ah) | 12,0 |
|---|---|
| Maximum cranking amps A | 90 |
| Alternator output A/V/rpm | 30/13,2/2000 |
Service checks and adjustments
| Compression pressure bar | 10,0-13,0 |
|---|---|
| Oil pressure bar/rpm | 0,3/700 |
| Radiator cap bar | 0,90-1,20 |
| Thermostat opens °C | 80-84 |
Fuel system
| System pressure bar | 2,7-3,1 |
|---|---|
| Regulated pressure with vacuum bar | 2,0-2,4 |
| Engine coolant temperature (ECT) sensor Ohm/°C | 2320-2590/20 |
| Crankshaft position (CKP) sensor/engine speed (RPM) sensor Ohm | 1630-2740 |
| Lambda sensor (Oxygen) heater Ohm | 11,0-16,0 |
Tightening torques
Cylinder head bolt torque
The cylinder head bolts on the Toyota Landcruiser 4.7 V8 (2008–2012) are tightened in 4 stages: 20 Nm, then 40 Nm, then 90°, then a final 90°.
| Cylinder head | |
|---|---|
| Tighten | 20 Nm |
| Tighten | 40 Nm |
| Tighten | 90° |
| Tighten | 90° |
| Cylinder head instructions | — |
|---|---|
| Cylinder head | |
| View more information | — |
| Other engine tightening torques | |
| Main bearings Renew bolts/nuts | — |
| View more information | — |
| Main bearings | |
| Main bearings Stage 1 | 27 Nm |
| Main bearings Stage 2 | 90° |
| Big end bearings Renew bolts/nuts | — |
| View more information | — |
| Big end bearings | |
| Big end bearings Stage 1 | 25 Nm |
| Big end bearings Stage 2 | 90° |
| Oil pump to cylinder block | — |
| Oil pump to cylinder block | |
| Sump bolts | 8 Nm M12=28 Nm |
| Sump drain bolt | 39 Nm |
| Flywheel/driveplate | 30 Nm+90° |
| Crankshaft pulley/damper centre bolt | 245 Nm |
| Camshaft sprocket/gear | 75 Nm |
| Camshaft carrier/cap | 16 Nm |
| Camshaft/rocker cover | 6 Nm |
| Inlet manifold to cylinder head | 18 Nm |
| Exhaust manifold to cylinder head | 44 Nm |
| Exhaust downpipe to manifold | 54 Nm |
| Water pump | — |
| View more information | — |
| Water pump | |
| Spark plugs | 18 Nm |
| Fuel rail | 21 Nm |
| Crankshaft position (CKP) sensor/engine speed (RPM) sensor | 8 Nm |
| Camshaft position (CMP) sensor | 8 Nm |
| Engine coolant temperature (ECT) sensor | 20 Nm |
| Lambda sensor (Oxygen) | 44 Nm |
| Knock sensor (KS) | 20 Nm |
| Engine oil pressure switch | 15 Nm |
| Chassis tightening torques | |
| Front hub | — |
| Front hub | |
| Front hub - wheel bearing housing bolts | 99 Nm |
| Rear hub - wheel bearing housing bolts | 60 Nm |
| Steering wheel | 50 Nm |
| Steering rack/box mounting | 120 Nm |
| Steering track rod end | 69 Nm |
| Brake caliper/carrier to hub Front | 99 Nm |
| Brake caliper to carrier Rear | 88 Nm |
| Brake caliper/carrier to hub Rear | 95 Nm |
| ABS sensor Front | 8 Nm |
| ABS sensor Rear | 8 Nm |
| Road wheels | — |
Air conditioning
| No. of AC service connectors | 2 |
|---|---|
| Air conditioning restrictor type | Expansion valve |
| Compressor clutch/magnetic coupling | Yes |
| Compressor variable displacement solenoid | No |
| Air conditioning refrigerant Type | R134a |
| Air conditioning refrigerant quantity grams | — |
| 22 mm condenser | |
| Air conditioning oil group | PAG |
| Air conditioning oil Type | Dens Oil 8 |
| Air conditioning oil quantity cm³ | 135±15 |
| Air conditioning oil viscosity ISO | 46 |
Frequently asked questions
What is the firing order of the Toyota Landcruiser 4.7 V8?
The firing order for the Toyota Landcruiser 4.7 V8 (2008–2012) is 1-8-4-3-6-5-7-2.
What spark plugs does the Toyota Landcruiser 4.7 V8 use?
The Toyota Landcruiser 4.7 V8 (2008–2012) uses Denso SK20R11 spark plugs with a 1,1 mm electrode gap.
How much oil does the Toyota Landcruiser 4.7 V8 take?
The Toyota Landcruiser 4.7 V8 (2008–2012) takes 6.2 litres of engine oil with the filter. See the reference table for the complete engine oil entries and their conditions.
What are the valve clearances for the Toyota Landcruiser 4.7 V8?
Valve clearances for the Toyota Landcruiser 4.7 V8 (2008–2012) are 0,15-0,25 mm inlet and 0,25-0,35 mm exhaust, measured cold.
What is the cylinder head torque for the Toyota Landcruiser 4.7 V8?
The cylinder head bolts on the Toyota Landcruiser 4.7 V8 (2008–2012) are tightened in 4 stages: 20 Nm, then 40 Nm, then 90°, then a final 90°.
What is the minimum brake disc thickness for the Toyota Landcruiser 4.7 V8?
Brake discs on the Toyota Landcruiser 4.7 V8 (2008–2012) are replaced at a minimum thickness of 29 mm (ventilated) front and 16 mm rear.