Toyota1980–1987Technical specifications

Corolla Estate 1.3: Technical specifications

Workshop data for the 1.3-litre petrol (engine code 4K). Covers engine, fluids, service and torques: the figures to check before a job or a parts order.

Summary

Match the engine code (4K) to the vehicle before ordering parts or applying these figures.

Vehicle specifications

Overview

Make
Toyota
Model
Corolla Estate
Years
1980–1987
Fuel
Petrol
Engine code
4K

Performance & efficiency

Power
44 kW (60 hp)
Engine size
1,290 cc
Cylinders
4 · OHV
Compression ratio
9.0:1
Fuel system
Aisan

Fluids & capacities

Engine oil (with the filter)
3.5 litres
All 83 specifications below

Engine & identification

Vehicle identification

No. of cylinders Type4/OHV
Capacity (Fiscal) cc1290 (1281)
Compression ratio :19,0
Suitable for unleaded petrolYes
Minimum octane rating RON91
Ignition system TypeSZ
Ignition system DescriptionCB
Fuel system MakeAisan
Fuel system DescriptionCarb-2V

Ignition system

Ignition coil MakeDenso
Ballast resistance Ohm1,3-1,5
Primary resistance Ohm1,4
Secondary resistance Ohm10700-14500
Distributor (ECM) MakeDenso
Distributor (ECM) No.26310
Contact breaker gap/trigger air gap mm0,45
Dwell angle °(%)52 (58)

Firing order

The firing order for the Toyota Corolla Estate 1.3 (1980–1987) is 1-3-4-2.

Firing order1-3-4-2

Valve clearances

Valve clearances for the Toyota Corolla Estate 1.3 (1980–1987) are 0,20 mm inlet and 0,30 mm exhaust, measured hot.

Valve clearance - INLET mm0,20 hot
Valve clearance - EXHAUST mm0,30 hot

Engine oil & fluids

Engine oil

The Toyota Corolla Estate 1.3 (1980–1987) takes 3.5 litres of engine oil with the filter.

A listed engine oil option is SAE 15W-40 for moderate climates, with API/ACEA classification SE.

A listed engine oil option is SAE 20W-50 as an alternative for moderate climates.

Manual gearbox

The manual gearbox has a listed capacity of 1.7 litres. The specified oil is SAE 80W-90.

Coolant

The listed total cooling-system capacity is 5.8 litres.

Grades, filling conditions and capacities

Lubricants and capacities — complete reference
Engine oil options
Ambient temperature range Moderate climate
Engine oil grade SAE 15W-40
Engine oil classification API/ACEA SE
Ambient temperature range Moderate climate alternative
Engine oil grade SAE 20W-50
Engine with filter(s) litres 3.5
Other lubricants and capacities
Manual transmission oil grade SAE 80W-90
Manual transmission litres 1.7
Automatic transmission fluid Type ATF-F
Automatic transmission (drain & refill) litres 4.7
Differential oil grade - rear SAE 90W
Differential rear litres 1.3
Cooling system - total capacity litres 5.8

Service & electrical

Ignition timing

Basic ignition timing for the Toyota Corolla Estate 1.3 (1980–1987) is 8° BTDC at 800 rpm.

Ignition timingWithout vacuum
Ignition timing - basic BTDC °Engine/rpm8/800
Ignition timing - alternative °Engine/rpm82-=5/700

Battery

The Toyota Corolla Estate 1.3 (1980–1987) uses a 12 V, 45 Ah battery (reserve capacity 60 minutes).

Battery V/RC(Ah)12/60 (45)

Spark plugs

The Toyota Corolla Estate 1.3 (1980–1987) uses NGK BPR5EA-L spark plugs with a 0,8 mm electrode gap.

Spark plugs Original equipmentNGK
Spark plug TypeBPR5EA-L
Electrode gap mm0,8
Spark plugs MakeChampion
Spark plug TypeRN9YCC
Electrode gap mm0,8
Spark plugs MakeNGK
Spark plug TypeBPR5EAL
Electrode gap mm0,8

Tuning and emissions

Ignition advanceWithout vacuum and basic timing
Ignition advance checks °Engine/rpm11-13/3500
Ignition advance checks °Engine/rpm27-29/5400
Ignition advance checks °Engine/rpm27-29/6000
Vacuum checkIgnition timing advances
Vacuum range °Engine17-19
Vacuum starts mbar133
Vacuum ends mbar293
Idle speed rpm750
Oil temperature °C60-80
CO level at idle speed - tailpipe Vol. % CO1,0±0,5
HC level at idle speed ppm300
HC level at idle - alternative ppm-1982=400
CO2 level at idle speed Vol. % CO213-16
O2 level at idle speed Vol. % O20,5-2,0

Starting and charging

Starter motor MakeDenso
Starter motor Type12V 0,6-0,8 kW
Minimum starting voltage V11,0
Maximum cranking amps A122-149
Alternator MakeNippon Denso
Alternator output A/V/rpm45/14/2500
Regulated voltage V13,8-14,8

Service checks and adjustments

Compression pressure bar9,0-11,0
Radiator cap bar0,60-0,90
Thermostat opens °C88
Drive belt size - alternator mm9,5x875
Drive belt tension - alternator/PAS/AC mm8-12

Fuel system

Fuel pump delivery pressure bar0,2-0,3

Tightening torques

Cylinder head bolt torque

The cylinder head bolt torque for the Toyota Corolla Estate 1.3 (1980–1987) is 54-66 Nm.

Cylinder head
Tighten54-66 Nm
Cylinder head instructions—
Other engine tightening torques
Main bearings Stage 127-33 Nm
Main bearings Stage 254-66 Nm
Big end bearings Stage 120-21 Nm
Big end bearings Stage 240-52 Nm
Flywheel/driveplate54-66 Nm
Crankshaft pulley/damper centre bolt74-100 Nm
Spark plugs15-21 Nm
Chassis tightening torques
Road wheels90-120 Nm

Frequently asked questions

What is the firing order of the Toyota Corolla Estate 1.3?

The firing order for the Toyota Corolla Estate 1.3 (1980–1987) is 1-3-4-2.

What spark plugs does the Toyota Corolla Estate 1.3 use?

The Toyota Corolla Estate 1.3 (1980–1987) uses NGK BPR5EA-L spark plugs with a 0,8 mm electrode gap.

How much oil does the Toyota Corolla Estate 1.3 take?

The Toyota Corolla Estate 1.3 (1980–1987) takes 3.5 litres of engine oil with the filter. A listed engine oil option is SAE 15W-40 for moderate climates, with API/ACEA classification SE. A listed engine oil option is SAE 20W-50 as an alternative for moderate climates.

What are the valve clearances for the Toyota Corolla Estate 1.3?

Valve clearances for the Toyota Corolla Estate 1.3 (1980–1987) are 0,20 mm inlet and 0,30 mm exhaust, measured hot.

What is the cylinder head torque for the Toyota Corolla Estate 1.3?

The cylinder head bolt torque for the Toyota Corolla Estate 1.3 (1980–1987) is 54-66 Nm.

What is the ignition timing for the Toyota Corolla Estate 1.3?

Basic ignition timing for the Toyota Corolla Estate 1.3 (1980–1987) is 8° BTDC at 800 rpm.