Alfa Romeo1971–1977Technical specifications

2000 Berlina 2.0: Technical specifications

Workshop data for the 2-litre petrol (engine code 105). Covers engine, fluids, service and torques: the figures to check before a job or a parts order.

Summary

Match the engine code (105) to the vehicle before ordering parts or applying these figures.

Vehicle specifications

Overview

Make
Alfa Romeo
Model
2000 Berlina
Years
1971–1977
Fuel
Petrol
Engine code
105

Performance & efficiency

Power
96 kW (131 hp)
Engine size
1,962 cc
Cylinders
4 · OHC
Compression ratio
9.0:1
Fuel system
Weber
All 73 specifications below

Engine & identification

Vehicle identification

No. of cylinders Type4/OHC
Capacity (Fiscal) cc1962 (1948)
Compression ratio :19,0
Suitable for unleaded petrolNo
Minimum octane rating RON98
Ignition system MakeBosch
Ignition system TypeSZ
Ignition system DescriptionCB
Fuel system MakeWeber
Fuel system Type40 DCOE
Fuel system DescriptionCarb-2V

Ignition system

Ignition coil MakeBosch
Ignition coil Type0 221 119 008
Ignition coil supply voltage + with ballast V11,0
Primary resistance Ohm2,9-3,4
Distributor (ECM) MakeBosch
Distributor (ECM) No.0 231 129 036
Contact breaker gap/trigger air gap mm0,4
Dwell angle °(%)62-68 (69-76)

Firing order

The firing order for the Alfa Romeo 2000 Berlina 2.0 (1971–1977) is 1-3-4-2.

Firing order1-3-4-2

Valve clearances

Valve clearances for the Alfa Romeo 2000 Berlina 2.0 (1971–1977) are 0,50 mm inlet and 0,55 mm exhaust, measured cold.

Valve clearance - INLET mm0,50 cold
Valve clearance - EXHAUST mm0,55 cold

Engine oil & fluids

Engine oil

The specified engine oil grade is SAE 10W-50 for moderate climates, with API/ACEA classification SE.

Manual gearbox

The manual gearbox has a listed capacity of 2.0 litres.

Coolant

The listed total cooling-system capacity is 9.5 litres.

Grades, filling conditions and capacities

Lubricants and capacities — complete reference
Engine oil options
Ambient temperature range Moderate climate
Engine oil grade SAE 10W-50
Engine oil classification API/ACEA SE
Other lubricants and capacities
Manual transmission litres 2.0
Differential rear litres 1.5
Cooling system - total capacity litres 9.5

Service & electrical

Battery

The Alfa Romeo 2000 Berlina 2.0 (1971–1977) uses a 12 V, 60 Ah battery (reserve capacity 90 minutes).

Battery V/RC(Ah)12/90 (60)

Spark plugs

The Alfa Romeo 2000 Berlina 2.0 (1971–1977) uses Bosch W7DC spark plugs with a 0,7 mm electrode gap.

Spark plugs Original equipmentLodge
Spark plug Type2HL
Electrode gap mm0,5-0,6
Spark plugs MakeBosch
Spark plug TypeW7DC
Electrode gap mm0,7
Spark plugs MakeChampion
Spark plug TypeN4C
Electrode gap mm0,7
Spark plugs MakeNGK
Spark plug TypeB7ES
Electrode gap mm0,7

Tuning and emissions

Static timing2-4
Ignition timingWithout vacuum
Ignition timing - basic BTDC °Engine/rpm37-40/4600
Ignition advanceWithout vacuum and basic timing
Ignition advance checks °Engine/rpm1-9/1000
Ignition advance checks °Engine/rpm12-22/2000
Ignition advance checks °Engine/rpm17-28/3000
Idle speed rpm700
Oil temperature °C70
CO level at idle speed - tailpipe Vol. % CO2,5-3,0
HC level at idle speed ppm500
CO2 level at idle speed Vol. % CO213-16
O2 level at idle speed Vol. % O20,5-2,0

Starting and charging

Starter motor MakeBosch
Starter motor Type0 001 211 987
Maximum cranking amps A162-198
Alternator MakeBosch
Alternator output A/V/rpm65/14/2400
Voltage regulator Type0 190 601 006
Regulated voltage V13,9-14,8

Service checks and adjustments

Oil pressure bar/rpm3,5-5,0
Thermostat opens °C82
Drive belt size - alternator mm9,5x825
Drive belt tension - alternator/PAS/AC mm10

Tightening torques

Cylinder head bolt torque

The cylinder head bolt torque for the Alfa Romeo 2000 Berlina 2.0 (1971–1977) is 79-81 Nm.

Cylinder head
Tighten79-81 Nm
Cylinder head instructions—
Other engine tightening torques
Main bearings Stage 123-25 Nm
Main bearings Stage 247-50 Nm
Big end bearings Stage 125-26 Nm
Big end bearings Stage 250-53 Nm
Flywheel/driveplate97-100 Nm
Spark plugs25-35 Nm
Chassis tightening torques
Road wheels98 Nm

Frequently asked questions

What is the firing order of the Alfa Romeo 2000 Berlina 2.0?

The firing order for the Alfa Romeo 2000 Berlina 2.0 (1971–1977) is 1-3-4-2.

What spark plugs does the Alfa Romeo 2000 Berlina 2.0 use?

The Alfa Romeo 2000 Berlina 2.0 (1971–1977) uses Bosch W7DC spark plugs with a 0,7 mm electrode gap.

How much oil does the Alfa Romeo 2000 Berlina 2.0 take?

The specified engine oil grade is SAE 10W-50 for moderate climates, with API/ACEA classification SE.

What are the valve clearances for the Alfa Romeo 2000 Berlina 2.0?

Valve clearances for the Alfa Romeo 2000 Berlina 2.0 (1971–1977) are 0,50 mm inlet and 0,55 mm exhaust, measured cold.

What is the cylinder head torque for the Alfa Romeo 2000 Berlina 2.0?

The cylinder head bolt torque for the Alfa Romeo 2000 Berlina 2.0 (1971–1977) is 79-81 Nm.

What battery does the Alfa Romeo 2000 Berlina 2.0 use?

The Alfa Romeo 2000 Berlina 2.0 (1971–1977) uses a 12 V, 60 Ah battery (reserve capacity 90 minutes).

More on the 2000 Berlina