Model Reports 4 min read Updated 18 Oct 2026

SEAT Toledo 2014: reliability & common MOT faults

In 2025, 68 in every 100 first MOTs on a 2014 SEAT Toledo were passes.

Summary

With 773 first tests, there are too few to say whether the 2014 SEAT Toledo differs from the model years either side. Treat the faults below as a checklist.

At a glance

How 773 first tests went in 2025.

Passed first time
68 in every 100
Did not pass first time
32 in every 100249 failed first-attempt tests
The typical car
11 yearsabout 97,488 miles
First tests counted
773

How we count this. Data: UK MOT open data, 2025. Only Class 4 cars on their first MOT of the year are counted. A car that fails and is fixed at the test station still counts as a fail in the first-attempt rate. These are raw results, not adjusted for age, mileage, or peer mix. The MOT does not test engine or gearbox internals.

Note:

These are patterns across 2014 SEAT Toledo vehicles in 2025, not a prediction that any one car will have them. Faults are grouped by part of the car. A wear pattern follows age and use more than the way the car was built. They come from MOT defect codes, not manufacturer bulletins, recalls or a diagnosis of any one car.

Suspension

Two faults. The strongest is the suspension arm pins and bushes (front): 3.0 times as often as on similar cars.

Figures below are measured across the 249 failed first attempts in 2025 that had a mileage recorded, which allows a like-for-like comparison.

We only list faults with at least 20 failures and a rate of about 2.0 times that of similar cars, which keeps one-off results out of the list.

Suspension arm pins and bushes (front)

Failed on 36 first tests3.0 times as often as similar carsLikely evidence

What it means

Pins and bushes on suspension arms fail as Major when they are excessively worn. They are graded Dangerous when likely to become detached. DVSA uses the same wording for a suspension joint.

Coil spring (front)

Failed on 35 first tests2.3 times as often as similar carsPossible evidence

What it means

A missing bump stop rubber is not a reason to fail a coil spring. When the vehicle is jacked and lowered, a spring that does not correctly locate as the suspension returns to its normal running position is rejected as insecurely attached. A missing spring is Major, and graded Dangerous where directional control is affected.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage.

Body and structure

One fault: drive shaft joints and boots (front), 2.2 times as often as on similar cars.

Drive shaft joints and boots (front)

Failed on 25 first tests2.2 times as often as similar carsPossible evidence

What it means

A constant velocity boot that is only severely deteriorated is Minor. It is Major once it is missing, split or insecure so that it no longer prevents the ingress of dirt. A transmission joint excessively worn is Major, and graded Dangerous when it is so worn it is likely to fail.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage.

Lamps and electrical

One wear pattern: headlight aim (front), 2.1 times as often as on similar cars.

Headlight aim (front)

Failed on 25 first tests2.1 times as often as similar carsWear pattern

What it means

Beam aim too high, too low or off to either side is Major. Where a driver's beam aim control is fitted, the aim is tested without altering the setting, and rechecked at the highest setting only if it would fail for being too low. Masks or converter kits on right hand dip headlamps are acceptable.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage.

Advisories

Other things testers noted as worn or close to failing, more often than on similar cars.

An advisory is a note from the tester about something that has not failed yet. It is an early warning, not a fail.

Shock absorbers (front)

Noted on 36 first tests4.0 times as often as similar carsElevated evidence

Brake discs (rear)

Noted on 49 first tests2.6 times as often as similar carsWear pattern

Data: UK MOT open data, 2025. Counts cover advisories recorded on failed first tests only, compared with cars of the same age and mileage.

MOT pass rates

How first tests ended, and how the pass rates are counted.

Passed first time
68in every 100
Passed on the first test.
Fixed at the station
6in every 100
Failed, then fixed at the test station the same day.
Failed
26in every 100
Did not pass, and were not fixed at the test station.

First-attempt pass 67.8% of 773 first tests (2025): only cars that passed first time count. Official-style pass 74.0%: cars fixed at the test station also count as a pass. The 6 fixed and the 26 not fixed make the 32 in every 100 that did not pass first time.

Petrol and diesel

First testsPassed first time, as tested
Petrol41971
Diesel35464

Figures are in every 100 first tests.

Same model, other years

Passed first time in every 100, all tested in 2025.

406080100201320142015201620172018Older carsNewer cars
406080100201320142015201620172018Newer cars

Newer cars are younger, so look for a jump rather than the climb. A year earlier (2024), when these cars were a year younger, 69 in every 100 passed first time.

YearPassed first timeFirst tests
201363 in every 100721
2014 This car68 in every 100773
201569 in every 100635
201670 in every 100481
201770 in every 100662
201876 in every 1001,058

FAQs

Short answers about how to read this model-year guide.

With 773 first tests, there are too few to say whether the 2014 SEAT Toledo differs from the model years either side. Treat the faults below as a checklist. In 2025, 67.8% of 773 first MOTs on the 2014 SEAT Toledo passed first time (PRS: items fixed at the station the same day, counted as a fail). The official-style rate including PRS is 74.0%. Among 249 failed first-attempt MOT tests (test year 2025), Suspension arm pins and bushes (front) appears more often than on similar cars (14.5% of those tests; 36 observed failures; about 3.0× more often than similar cars). There is no single reliability score here; this is a pre-purchase checklist built from DVSA open data, not a guarantee for any individual car.
Among failed first-attempt tests we highlight patterns that appear more often than on similar cars. Top example: Suspension arm pins and bushes (front) (14.5% of those tests; 36 observed failures; about 3.0× more often than similar cars). These are statistical signals, not a diagnosis of any individual car.
Suspension arm pins and bushes (front) shows up more often than on similar cars (14.5% of those tests; 36 observed failures; about 3.0× more often than similar cars). That does not prove a design fault. Age, mileage, and how the car was used still matter. Treat it as a pre-purchase checkpoint, not a manufacturer service bulletin.
Common MOT problem areas for the 2014 SEAT Toledo include Suspension arm pins and bushes (front), Coil spring (front), Drive shaft joints and boots (front). These are the faults that stand out compared with similar cars, not a complete list of what can go wrong on any individual car.
Advisories flag issues noted at the test and are not a fail rate. We show advisory patterns that appear more often than on similar cars among failed first-attempt tests, separate from common failure rows. Use them as early-warning checks, not as a pass/fail score.
This page highlights MOT failure patterns for the 2014 SEAT Toledo (registration year) using UK DVSA open data for the selected test year. Patterns are compared with cars of a similar age and mileage. It is a buyer checklist from MOT defect statistics, not a full service history or manufacturer service-bulletin list.
No. MOT tests do not cover engine internals, gearboxes, or many electronic modules. Patterns here come from MOT defect statistics only and should not be read as engine or gearbox reliability scores.

About this data

How this page is built and what it can (and can't) say.

These figures come from UK MOT open data for this model year. We surface common failure patterns against similar cars, not a full reliability score, and not a pass/fail verdict on any individual vehicle.

2024 2025

What we include

UK Class 4 cars only. Normal MOT tests (not retests); first test per vehicle per calendar year; results pass, PRS, or fail.

Same-day repairs

PRS means the car failed items that were fixed at the test station and then passed the same day. We count PRS as a first-attempt fail in headline rates so same-day repairs do not hide problems.

How we compare

We compare this model year with other Class 4 cars of similar age and mileage in the same test year. This model family is left out of the peer group so the car is not measured against itself.

What this does not cover

  • MOTs do not cover engine internals, gearboxes, or many electronics; this is not a full reliability score.
  • Common faults come from MOT defect stats, not manufacturer TSBs or recalls.
  • Age and mileage matching reduces, but does not remove, differences in how cars were used and maintained.
  • If the data for a car is too thin to say anything useful, we say so rather than guess.

Contains public sector information licensed under the Open Government Licence v3.0.

Check any vehicle’s MOT history

Full MOT history, mileage records, and reliability insights for any UK vehicle.

Run a free check