Honda CR-V 2000: reliability & common MOT faults

In 2025, 52 in every 100 first MOTs on a 2000 Honda CR-V were passes. Most common reason for a fail: Suspension mounting area (rear).

Summary

With 531 first tests, there are too few to say whether the 2000 Honda CR-V differs from the model years either side. Treat the faults below as a checklist.

At a glance

How 531 first tests went in 2025.

Passed first time
52 in every 100
Did not pass first time
48 in every 100256 failed first-attempt tests
The typical car
25 yearsabout 119,432 miles
First tests counted
531

What failed most often

  1. Suspension mounting area (rear)20 in every 100 failed tests
  2. Petrol emissions (with catalyst)20 in every 100 failed tests

How we count this. Data: UK MOT open data, 2025. Only Class 4 cars on their first MOT of the year are counted. A car that fails and is fixed at the test station still counts as a fail in the first-attempt rate. These are raw results, not adjusted for age, mileage, or peer mix. The MOT does not test engine or gearbox internals.

Note:

These are patterns across 2000 Honda CR-V vehicles in 2025, not a prediction that any one car will have them. Faults are grouped by part of the car. They come from MOT defect codes, not manufacturer bulletins, recalls or a diagnosis of any one car.

Suspension

Two faults. The strongest is the suspension arm ball joint (front): 2.8 times as often as on similar cars.

Figures below are measured across the 256 failed first attempts in 2025 that had a mileage recorded, which allows a like-for-like comparison.

We only list faults with at least 20 failures and a rate of about 2.0 times that of similar cars, which keeps one-off results out of the list.

Suspension arm ball joint (front)

Failed on 26 first tests2.8 times as often as similar carsPossible evidence

What it means

A suspension arm ball joint is failed under the general suspension pin, bush or joint wording. Excessively worn is Major, and likely to become detached is graded Dangerous.

Suspension mounting area (rear)

Failed on 52 first tests2.2 times as often as similar carsPossible evidence

What it means

The load bearing structure within a set distance of a sub-frame, spring or suspension component mounting is a prescribed area. Major applies when its strength or continuity is significantly reduced or it is inadequately repaired. Dangerous applies when it is so weakened that control of the vehicle is likely to be adversely affected.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage.

Advisories

Other things testers noted as worn or close to failing, more often than on similar cars.

An advisory is a note from the tester about something that has not failed yet. It is an early warning, not a fail.

Suspension arm pins and bushes (rear)

Noted on 50 first tests10.0 times as often as similar carsElevated evidence

Number plates (front)

Noted on 22 first tests2.3 times as often as similar carsElevated evidence

Data: UK MOT open data, 2025. Counts cover advisories recorded on failed first tests only, compared with cars of the same age and mileage.

MOT pass rates

How first tests ended, and how the pass rates are counted.

Passed first time
52in every 100
Passed on the first test.
Fixed at the station
7in every 100
Failed, then fixed at the test station the same day.
Failed
41in every 100
Did not pass, and were not fixed at the test station.

First-attempt pass 51.8% of 531 first tests (2025): only cars that passed first time count. Official-style pass 58.9%: cars fixed at the test station also count as a pass. The 7 fixed and the 41 not fixed make the 48 in every 100 that did not pass first time.

Same model, other years

Passed first time in every 100, all tested in 2025.

40608010020002005201020152020
406080100200020102020

Newer cars are younger, so look for a jump rather than the climb. A year earlier (2024), when these cars were a year younger, 53 in every 100 passed first time.

YearPassed first timeFirst tests
199952 in every 100343
2000 This car52 in every 100531
200155 in every 100891
200249 in every 1002,508
200350 in every 1003,782
200449 in every 1004,876
200553 in every 1006,998
200654 in every 1007,920
200757 in every 10011,743
200860 in every 1008,890
200964 in every 1008,492
201069 in every 1009,230
201171 in every 1009,222
201274 in every 10011,907
201380 in every 10013,543
201482 in every 10014,223
201583 in every 10013,859
201685 in every 10013,724
201786 in every 10011,531
201888 in every 1008,968
201991 in every 1008,055
202092 in every 1005,389
202192 in every 1005,635
202293 in every 1005,014

FAQs

Short answers about how to read this model-year guide.

With 531 first tests, there are too few to say whether the 2000 Honda CR-V differs from the model years either side. Treat the faults below as a checklist. In 2025, 51.8% of 531 first MOTs on the 2000 Honda CR-V passed first time (PRS: items fixed at the station the same day, counted as a fail). The official-style rate including PRS is 58.9%. Among 256 failed first-attempt MOT tests (test year 2025), Suspension arm ball joint (front) appears more often than on similar cars (10.2% of those tests; 26 observed failures; about 2.8× more often than similar cars). There is no single reliability score here; this is a pre-purchase checklist built from DVSA open data, not a guarantee for any individual car.
Ranked by how often they were actually recorded, the items that most often failed a 2000 Honda CR-V at the first attempt were Suspension mounting area (rear) (20.3%) and Petrol emissions (with catalyst) (19.5%), each as a share of the year's failed first attempts. That is what goes wrong most often on the car. The common faults table shows a different measure: faults that are unusual compared with similar cars.
Among failed first-attempt tests we highlight patterns that appear more often than on similar cars. Top example: Suspension arm ball joint (front) (10.2% of those tests; 26 observed failures; about 2.8× more often than similar cars). These are statistical signals, not a diagnosis of any individual car.
Suspension arm ball joint (front) shows up more often than on similar cars (10.2% of those tests; 26 observed failures; about 2.8× more often than similar cars). That does not prove a design fault. Age, mileage, and how the car was used still matter. Treat it as a pre-purchase checkpoint, not a manufacturer service bulletin.
Common MOT problem areas for the 2000 Honda CR-V include Suspension arm ball joint (front), Suspension mounting area (rear). These are the faults that stand out compared with similar cars, not a complete list of what can go wrong on any individual car.
Advisories flag issues noted at the test and are not a fail rate. We show advisory patterns that appear more often than on similar cars among failed first-attempt tests, separate from common failure rows. Use them as early-warning checks, not as a pass/fail score.
This page highlights MOT failure patterns for the 2000 Honda CR-V (registration year) using UK DVSA open data for the selected test year. Patterns are compared with cars of a similar age and mileage. It is a buyer checklist from MOT defect statistics, not a full service history or manufacturer service-bulletin list.
No. MOT tests do not cover engine internals, gearboxes, or many electronic modules. Patterns here come from MOT defect statistics only and should not be read as engine or gearbox reliability scores.

About this data

How this page is built and what it can (and can't) say.

These figures come from UK MOT open data for this model year. We surface common failure patterns against similar cars, not a full reliability score, and not a pass/fail verdict on any individual vehicle.

2024 2025

What we include

UK Class 4 cars only. Normal MOT tests (not retests); first test per vehicle per calendar year; results pass, PRS, or fail.

Same-day repairs

PRS means the car failed items that were fixed at the test station and then passed the same day. We count PRS as a first-attempt fail in headline rates so same-day repairs do not hide problems.

How we compare

We compare this model year with other Class 4 cars of similar age and mileage in the same test year. This model family is left out of the peer group so the car is not measured against itself.

What this does not cover

  • MOTs do not cover engine internals, gearboxes, or many electronics; this is not a full reliability score.
  • Common faults come from MOT defect stats, not manufacturer TSBs or recalls.
  • Age and mileage matching reduces, but does not remove, differences in how cars were used and maintained.
  • If the data for a car is too thin to say anything useful, we say so rather than guess.

Contains public sector information licensed under the Open Government Licence v3.0.

Check any vehicle’s MOT history

Full MOT history, mileage records, and reliability insights for any UK vehicle.

Run a free check