Audi Q7 2018: reliability & common MOT faults

In 2025, 85 in every 100 first MOTs on a 2018 Audi Q7 were passes. Most common reason for a fail: Coil spring (rear).

Summary

The 2018 Audi Q7 follows the pattern of the model years either side.

At a glance

How 4,520 first tests went in 2025.

Passed first time
85 in every 100
Did not pass first time
15 in every 100670 failed first-attempt tests
The typical car
7 yearsabout 67,195 miles
First tests counted
4,520

What failed most often

  1. Coil spring (rear)23 in every 100 failed tests
  2. Tyre condition (front)18 in every 100 failed tests
  3. Suspension arm pins and bushes (front)9 in every 100 failed tests

How we count this. Data: UK MOT open data, 2025. Only Class 4 cars on their first MOT of the year are counted. A car that fails and is fixed at the test station still counts as a fail in the first-attempt rate. These are raw results, not adjusted for age, mileage, or peer mix. The MOT does not test engine or gearbox internals.

Note:

These are patterns across 2018 Audi Q7 vehicles in 2025, not a prediction that any one car will have them. Faults are grouped by part of the car. A wear pattern follows age and use more than the way the car was built. They come from MOT defect codes, not manufacturer bulletins, recalls or a diagnosis of any one car.

Suspension

Two faults. The strongest is the coil spring (rear): 6.6 times as often as on similar cars.

Figures below are measured across the 670 failed first attempts in 2025 that had a mileage recorded, which allows a like-for-like comparison.

We only list faults with at least 20 failures and a rate of about 2.0 times that of similar cars, which keeps one-off results out of the list.

Coil spring (rear)

Failed on 152 first tests6.6 times as often as similar carsStrong evidence

What it means

A missing bump stop rubber is not a reason to fail a coil spring. When the vehicle is jacked and lowered, a spring that does not correctly locate as the suspension returns to its normal running position is rejected as insecurely attached. A missing spring is Major, and graded Dangerous where directional control is affected.

Suspension arm pins and bushes (front)

Failed on 62 first tests3.7 times as often as similar carsLikely evidence

What it means

Pins and bushes on suspension arms fail as Major when they are excessively worn. They are graded Dangerous when likely to become detached. DVSA uses the same wording for a suspension joint.

Also noted as an advisory

Testers also noted it as an advisory, worn but not yet failing, on 108 first tests, 3.6 times as often as on similar cars.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage. Advisories count notes recorded on failed first tests only.

Number plates and VIN

Two faults. The strongest is the number plates (rear): 4.8 times as often as on similar cars.

Number plates (rear)

Failed on 26 first tests4.8 times as often as similar carsPossible evidence

What it means

A number plate that is missing, illegible, showing an incorrect registration or so insecure that it is likely to fall off is Major. Testers do not measure the characters or their spacing and reject them only if they are obviously incorrect. Delamination and the position of fixing screws or bolts get particular attention, as they can prevent number plate recognition cameras identifying the vehicle.

Number plates (front)

Failed on 20 first tests4.2 times as often as similar carsPossible evidence

What it means

A number plate that is missing, illegible, showing an incorrect registration or so insecure that it is likely to fall off is Major. Testers do not measure the characters or their spacing and reject them only if they are obviously incorrect. Delamination and the position of fixing screws or bolts get particular attention, as they can prevent number plate recognition cameras identifying the vehicle.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage.

Tyres

One wear pattern: tyre tread depth (rear), 2.0 times as often as on similar cars.

Tyre tread depth (rear)

Failed on 54 first tests2.0 times as often as similar carsWear pattern

What it means

Only primary grooves count when tread depth is assessed: those holding the wear indicators, or cut as deep as those when new. Shallower secondary grooves are ignored. Tread depth below the minimum for the vehicle is Dangerous, and so is a pattern not visible over the whole tread, but that second row applies only to vehicles that need the lower minimum.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage.

MOT pass rates

How first tests ended, and how the pass rates are counted.

Passed first time
85in every 100
Passed on the first test.
Fixed at the station
2in every 100
Failed, then fixed at the test station the same day.
Failed
13in every 100
Did not pass, and were not fixed at the test station.

First-attempt pass 85.2% of 4,520 first tests (2025): only cars that passed first time count. Official-style pass 86.5%: cars fixed at the test station also count as a pass. The 2 fixed and the 13 not fixed make the 15 in every 100 that did not pass first time.

Same model, other years

Passed first time in every 100, all tested in 2025.

406080100201020152018Older carsNewer cars
40608010020102018Older cars

Newer cars are younger, so look for a jump rather than the climb. A year earlier (2024), when these cars were a year younger, 84 in every 100 passed first time.

YearPassed first timeFirst tests
200673 in every 100905
200772 in every 1002,337
200872 in every 1001,745
200973 in every 1001,062
201077 in every 1001,280
201179 in every 1001,590
201280 in every 1002,111
201382 in every 1002,959
201481 in every 1002,993
201583 in every 1003,031
201681 in every 1004,542
201783 in every 1004,975
2018 This car85 in every 1004,520
201986 in every 1004,259
202090 in every 1003,428
202189 in every 1002,965
202289 in every 1003,033

If you are buying one

What this year's MOT record means for the decision in front of you.

Mileage makes a modest difference on a 2018 Audi Q7.

Of 2018 Audi Q7 vehicles with under 51,000 miles, 87 in every 100 passed their 2025 MOT first time. With 87,000 miles or more, 82 in every 100 did.

Under 51,000910 tests
87
51,000–62,000888 tests
87
62,000–73,000 Typical car924 tests
85
73,000–87,000888 tests
84
87,000 and over909 tests
82

What to check at your mileage

How often each fault turned up on a failed first test, by the car's mileage. Read it as: what is likely to need looking at on a car like the one in front of you.

Under 51,00062,000–73,00087,000 and over
Coil spring (rear)3.73.63.2
Tyre condition (front)2.02.93.4
Suspension arm pins and bushes (front)1.01.51.1
Tyre tread depth (rear)0.71.31.9

Faults per 100 first tests, by the car's mileage at the test.


When a car fails

55in every 100

of failed cars had one item to fix.

15in every 100

of failed cars had three or more items to fix.

5in every 100

of all first tests had a defect the tester marked dangerous (unsafe to drive away).


Every figure here is a first-attempt MOT rate from DVSA open data for this model line, for cars of this model year tested in 2025. Each mileage band holds a fifth of the tests. MOTs do not test engine or gearbox internals, so this is a pre-purchase checklist, not a full reliability score.

FAQs

Short answers about how to read this model-year guide.

The 2018 Audi Q7 follows the pattern of the model years either side. Its main cause of failure was Coil spring (rear), about 23 in every 100 failed tests. In 2025, 85.2% of 4,520 first MOTs on the 2018 Audi Q7 passed first time (PRS: items fixed at the station the same day, counted as a fail). The official-style rate including PRS is 86.5%. Among 670 failed first-attempt MOT tests (test year 2025), Coil spring (rear) appears more often than on similar cars (22.7% of those tests; 152 observed failures; about 6.6× more often than similar cars). There is no single reliability score here; this is a pre-purchase checklist built from DVSA open data, not a guarantee for any individual car.
Ranked by how often they were actually recorded, the items that most often failed a 2018 Audi Q7 at the first attempt were Coil spring (rear) (22.7%), Tyre condition (front) (18.1%) and Suspension arm pins and bushes (front) (9.3%), each as a share of the year's failed first attempts. That is what goes wrong most often on the car. The common faults table shows a different measure: faults that are unusual compared with similar cars.
Among failed first-attempt tests we highlight patterns that appear more often than on similar cars. Top example: Coil spring (rear) (22.7% of those tests; 152 observed failures; about 6.6× more often than similar cars). These are statistical signals, not a diagnosis of any individual car.
Coil spring (rear) shows up more often than on similar cars (22.7% of those tests; 152 observed failures; about 6.6× more often than similar cars). That does not prove a design fault. Age, mileage, and how the car was used still matter. Treat it as a pre-purchase checkpoint, not a manufacturer service bulletin.
Common MOT problem areas for the 2018 Audi Q7 include Coil spring (rear), Number plates (rear), Suspension arm pins and bushes (front). These are the faults that stand out compared with similar cars, not a complete list of what can go wrong on any individual car.
This page highlights MOT failure patterns for the 2018 Audi Q7 (registration year) using UK DVSA open data for the selected test year. Patterns are compared with cars of a similar age and mileage. It is a buyer checklist from MOT defect statistics, not a full service history or manufacturer service-bulletin list.
No. MOT tests do not cover engine internals, gearboxes, or many electronic modules. Patterns here come from MOT defect statistics only and should not be read as engine or gearbox reliability scores.

About this data

How this page is built and what it can (and can't) say.

These figures come from UK MOT open data for this model year. We surface common failure patterns against similar cars, not a full reliability score, and not a pass/fail verdict on any individual vehicle.

2024 2025

What we include

UK Class 4 cars only. Normal MOT tests (not retests); first test per vehicle per calendar year; results pass, PRS, or fail.

Same-day repairs

PRS means the car failed items that were fixed at the test station and then passed the same day. We count PRS as a first-attempt fail in headline rates so same-day repairs do not hide problems.

How we compare

We compare this model year with other Class 4 cars of similar age and mileage in the same test year. This model family is left out of the peer group so the car is not measured against itself.

What this does not cover

  • MOTs do not cover engine internals, gearboxes, or many electronics; this is not a full reliability score.
  • Common faults come from MOT defect stats, not manufacturer TSBs or recalls.
  • Age and mileage matching reduces, but does not remove, differences in how cars were used and maintained.
  • If the data for a car is too thin to say anything useful, we say so rather than guess.

Contains public sector information licensed under the Open Government Licence v3.0.

Check any vehicle’s MOT history

Full MOT history, mileage records, and reliability insights for any UK vehicle.

Run a free check