Audi A1 2013: reliability & common MOT faults

In 2025, 67 in every 100 first MOTs on a 2013 Audi A1 were passes. Most common reason for a fail: Suspension arm pins and bushes (front).

Summary

A 2013 Audi A1 passed first time about 2 in every 100 less often than the average of the 2012 and 2014 model years.

At a glance

How 21,298 first tests went in 2025.

Passed first time
67 in every 100
Did not pass first time
33 in every 1007,092 failed first-attempt tests
The typical car
12 yearsabout 82,921 miles
First tests counted
21,298

What failed most often

  1. Suspension arm pins and bushes (front)13 in every 100 failed tests
  2. Coil spring (front)13 in every 100 failed tests
  3. Tyre condition (front)12 in every 100 failed tests

How we count this. Data: UK MOT open data, 2025. Only Class 4 cars on their first MOT of the year are counted. A car that fails and is fixed at the test station still counts as a fail in the first-attempt rate. These are raw results, not adjusted for age, mileage, or peer mix. The MOT does not test engine or gearbox internals.

Note:

These are patterns across 2013 Audi A1 vehicles in 2025, not a prediction that any one car will have them. Faults are grouped by part of the car. A wear pattern follows age and use more than the way the car was built. They come from MOT defect codes, not manufacturer bulletins, recalls or a diagnosis of any one car.

Brakes

One wear pattern: brake discs (rear), 2.8 times as often as on similar cars.

Figures below are measured across the 7,083 of 7,092 failed first attempts (99.9%) that recorded an odometer reading in 2025. Mileage is needed to compare like with like.

We only list faults with at least 20 failures and a rate of about 2.0 times that of similar cars, which keeps one-off results out of the list.

Brake discs (rear)

Failed on 255 first tests2.8 times as often as similar carsWear pattern

What it means

A brake disc or drum must be significantly worn before it is rejected, and being worn below the manufacturer's recommended limits is not a reason in itself. Significantly and obviously worn is Major, as is contamination with oil or grease. A disc or drum that is fractured, insecure, seriously weakened or missing is graded Dangerous.

Also noted as an advisory

Testers also noted it as an advisory, worn but not yet failing, on 1,124 first tests, 2.3 times as often as on similar cars.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage. Advisories count notes recorded on failed first tests only.

Suspension

Two faults. The strongest is the suspension arm pins and bushes (front): 2.8 times as often as on similar cars.

Suspension arm pins and bushes (front)

Failed on 919 first tests2.8 times as often as similar carsPossible evidence

What it means

Pins and bushes on suspension arms fail as Major when they are excessively worn. They are graded Dangerous when likely to become detached. DVSA uses the same wording for a suspension joint.

Coil spring (rear)

Failed on 814 first tests2.6 times as often as similar carsPossible evidence

What it means

A missing bump stop rubber is not a reason to fail a coil spring. When the vehicle is jacked and lowered, a spring that does not correctly locate as the suspension returns to its normal running position is rejected as insecurely attached. A missing spring is Major, and graded Dangerous where directional control is affected.

Data: UK MOT open data, 2025. Compared with cars of the same age and mileage.

Advisories

Other things testers noted as worn or close to failing, more often than on similar cars.

An advisory is a note from the tester about something that has not failed yet. It is an early warning, not a fail. Advisories for the faults above are shown with those faults.

Macpherson strut pins and bushes (front)

Noted on 112 first tests2.3 times as often as similar carsPossible evidence

Data: UK MOT open data, 2025. Counts cover advisories recorded on failed first tests only, compared with cars of the same age and mileage.

MOT pass rates

How first tests ended, and how the pass rates are counted.

Passed first time
67in every 100
Passed on the first test.
Fixed at the station
4in every 100
Failed, then fixed at the test station the same day.
Failed
29in every 100
Did not pass, and were not fixed at the test station.

First-attempt pass 66.7% of 21,298 first tests (2025): only cars that passed first time count. Official-style pass 71.3%: cars fixed at the test station also count as a pass. The 4 fixed and the 29 not fixed make the 33 in every 100 that did not pass first time.

Petrol and diesel

First testsTypical mileagePassed first time, as testedPassed first time, same mileage
Petrol12,70873,072 miles6967
Diesel8,58997,923 miles6366

Figures are in every 100 first tests. Cars with more miles usually fail more often, so the same-mileage figure gives every fuel the mileage mix of all the cars in this year.

Same model, other years

Passed first time in every 100, all tested in 2025.

406080100201020132020Older carsNewer cars
406080100201020132020Newer cars

Newer cars are younger, so look for a jump rather than the climb. A year earlier (2024), when these cars were a year younger, 69 in every 100 passed first time.

YearPassed first timeFirst tests
201065 in every 1001,274
201164 in every 10015,034
201266 in every 10017,495
2013 This car67 in every 10021,298
201471 in every 10022,045
201574 in every 10022,636
201674 in every 10024,427
201777 in every 10021,991
201880 in every 10019,030
201984 in every 10019,545
202087 in every 10012,814
202189 in every 10013,504
202290 in every 10014,214

If you are buying one

What this year's MOT record means for the decision in front of you.

Mileage matters most on a 2013 Audi A1.

Of 2013 Audi A1 vehicles with under 58,000 miles, 77 in every 100 passed their 2025 MOT first time. With 109,000 miles or more, 59 in every 100 did.

Under 58,0004,240 tests
77
58,000–75,0004,239 tests
69
75,000–91,000 Typical car4,397 tests
65
91,000–109,0004,169 tests
63
109,000 and over4,241 tests
59

Petrol or diesel?

Typical mileagePassed first time,
as tested
Passed first time,
same mileage
Petrol73,072 miles6967
Diesel97,923 miles6366

Figures are in every 100 first tests. Petrol cars look better on the raw figures only because diesel cars have done more miles (typically 97,923 against 73,072). At the same mileage there is no clear difference between the two.


What to check at your mileage

How often each fault turned up on a failed first test, by the car's mileage. Read it as: what is likely to need looking at on a car like the one in front of you.

Under 58,00075,000–91,000109,000 and over
Suspension arm pins and bushes (front)3.04.35.3
Coil spring (front)4.24.24.7
Tyre condition (front)2.94.35.3
Drive shaft joints and boots (front)1.02.34.3
Headlight aim1.12.43.8

Faults per 100 first tests, by the car's mileage at the test.


When a car fails

40in every 100

of failed cars had one item to fix.

33in every 100

of failed cars had three or more items to fix.

9in every 100

of all first tests had a defect the tester marked dangerous (unsafe to drive away).


Every figure here is a first-attempt MOT rate from DVSA open data for this model line, for cars of this model year tested in 2025. Each mileage band holds a fifth of the tests. MOTs do not test engine or gearbox internals, so this is a pre-purchase checklist, not a full reliability score.

FAQs

Short answers about how to read this model-year guide.

A 2013 Audi A1 passed first time about 2 in every 100 less often than the average of the 2012 and 2014 model years. In 2025, 66.7% of 21,298 first MOTs on the 2013 Audi A1 passed first time (PRS: items fixed at the station the same day, counted as a fail). The official-style rate including PRS is 71.3%. Among 7,092 failed first-attempt MOT tests (test year 2025), Suspension arm pins and bushes (front) appears more often than on similar cars (13.0% of those tests; 919 observed failures; about 2.8× more often than similar cars). There is no single reliability score here; this is a pre-purchase checklist built from DVSA open data, not a guarantee for any individual car.
Ranked by how often they were actually recorded, the items that most often failed a 2013 Audi A1 at the first attempt were Suspension arm pins and bushes (front) (13.0%), Coil spring (front) (12.9%) and Tyre condition (front) (12.0%), each as a share of the year's failed first attempts. That is what goes wrong most often on the car. The common faults table shows a different measure: faults that are unusual compared with similar cars.
Among failed first-attempt tests we highlight patterns that appear more often than on similar cars. Top example: Suspension arm pins and bushes (front) (13.0% of those tests; 919 observed failures; about 2.8× more often than similar cars). These are statistical signals, not a diagnosis of any individual car.
Suspension arm pins and bushes (front) shows up more often than on similar cars (13.0% of those tests; 919 observed failures; about 2.8× more often than similar cars). That does not prove a design fault. Age, mileage, and how the car was used still matter. Treat it as a pre-purchase checkpoint, not a manufacturer service bulletin.
Common MOT problem areas for the 2013 Audi A1 include Suspension arm pins and bushes (front), Coil spring (rear). These are the faults that stand out compared with similar cars, not a complete list of what can go wrong on any individual car.
Advisories flag issues noted at the test and are not a fail rate. We show advisory patterns that appear more often than on similar cars among failed first-attempt tests, separate from common failure rows. Use them as early-warning checks, not as a pass/fail score.
This page highlights MOT failure patterns for the 2013 Audi A1 (registration year) using UK DVSA open data for the selected test year. Patterns are compared with cars of a similar age and mileage. It is a buyer checklist from MOT defect statistics, not a full service history or manufacturer service-bulletin list.
No. MOT tests do not cover engine internals, gearboxes, or many electronic modules. Patterns here come from MOT defect statistics only and should not be read as engine or gearbox reliability scores.

About this data

How this page is built and what it can (and can't) say.

These figures come from UK MOT open data for this model year. We surface common failure patterns against similar cars, not a full reliability score, and not a pass/fail verdict on any individual vehicle.

2024 2025

What we include

UK Class 4 cars only. Normal MOT tests (not retests); first test per vehicle per calendar year; results pass, PRS, or fail.

Same-day repairs

PRS means the car failed items that were fixed at the test station and then passed the same day. We count PRS as a first-attempt fail in headline rates so same-day repairs do not hide problems.

How we compare

We compare this model year with other Class 4 cars of similar age and mileage in the same test year. This model family is left out of the peer group so the car is not measured against itself.

What this does not cover

  • MOTs do not cover engine internals, gearboxes, or many electronics; this is not a full reliability score.
  • Common faults come from MOT defect stats, not manufacturer TSBs or recalls.
  • Age and mileage matching reduces, but does not remove, differences in how cars were used and maintained.
  • If the data for a car is too thin to say anything useful, we say so rather than guess.

Contains public sector information licensed under the Open Government Licence v3.0.

Check any vehicle’s MOT history

Full MOT history, mileage records, and reliability insights for any UK vehicle.

Run a free check