14 documented faults
Engine & fuel system
4 documented faults — symptoms, causes and workshop fixes.
Engine malfunction indicator lamp (MIL) illuminated.
All models with 3.0/4.4 Diesel engines.
Workshop instructions
Workshop procedure
- Check turbocharger (TC) intercooler for damage. Replace if necessary.
- Replace turbocharger (TC) intercooler hose.
Data: Motorwise Workshop. Bulletin 4.
Engine malfunction indicator lamp (MIL) illuminated.
All models with 4.4 Diesel engine.
What you'd notice
Poor engine performance.
The repair
Intake air temperature (IAT)/manifold absolute pressure (MAP) sensor faulty.
Workshop instructions
Workshop procedure
- Fit modified intake air temperature (IAT)/manifold absolute pressure (MAP) sensor.
Data: Motorwise Workshop. Bulletin 10.
Splashing noise heard under acceleration or braking at low speed.
All models with Diesel engines.
Lack of splash baffle in fuel tank.
Workshop instructions & parts2 parts
Workshop procedure
- Remove fuel tank.
- Remove fuel pump assembly from fuel tank.
- Fit fuel tank splash baffle.
- Refit components in reverse order of removal.
| Part | Part number | Qty |
|---|---|---|
| Fuel tank splash baffle | LR065678 | 1 |
| O-ring | LR000966 | 1 |
Data: Motorwise Workshop. Bulletin 13.
Rattling noise from underside of vehicle.
All models.
Sound insulation material on engine undertray loose due to failure of retaining clips.
Workshop instructions & parts1 part
Workshop procedure
- Remove and discard sound insulation material retaining clips.
- Fit new sound insulation material retaining nuts Fig.1273365.1 .
- View View more information
| Part | Part number | Qty |
|---|---|---|
| Nut | LR003643 | 1 |
Data: Motorwise Workshop. Bulletin 14.
Electrical & ignition
2 documented faults — symptoms, causes and workshop fixes.
Intermittent self-activation of alarm system siren.
All models.
What you'd notice
Audible warning sounds when locking vehicle. Bonnet open warning message displayed in instrument panel.
The repair
Bonnet switch faulty.
Workshop instructions & parts1 part
Workshop procedure
- Fit new bonnet switch. Bonnet switch integral to bonnet latch.
| Part | Part number | Qty |
|---|---|---|
| Bonnet switch | LR054331 | 1 |
Data: Motorwise Workshop. Bulletin 1.
Battery discharged after standing overnight.
All models, 2014-16.
What you'd notice
Clicking noise from load area when ignition switched ON. Low battery voltage warning displayed in instrument panel.
The repair
CAN data bus gateway control module does not switch to sleep mode due to software fault.
Workshop instructions
Workshop procedure
- Charge battery if necessary.
- Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
- If no fault(s) found: Re-program CAN data bus gateway control module with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.
Data: Motorwise Workshop. Bulletin 8.
Brakes
4 documented faults — symptoms, causes and workshop fixes.
Squeal from rear brakes when braking lightly at low speed.
All models with high-performance brakes, →2014.
Vibration between brake pads and discs.
Workshop instructions & parts2 parts
Workshop procedure
- Fit modified rear brake pads.
| Part | Part number | Qty |
|---|---|---|
| Rear brake pads | LR065492 | 1 |
| Brake pad wear sensor | LR033295 | 1 |
Data: Motorwise Workshop. Bulletin 2.
Squeal from front brakes when braking lightly at low speed.
All models with high-performance brakes, →2014.
Vibration between brake pads and discs.
Workshop instructions & parts3 parts
Workshop procedure
- Fit modified front brake pads.
| Part | Part number | Qty |
|---|---|---|
| Front brake pads | LR039526 | 1 |
| Brake pad wear sensor | LR033275 | 1 |
| Caliper bolt | LR033274 | 4 |
Data: Motorwise Workshop. Bulletin 3.
Electric parking brake (EPB) warning message displayed in instrument panel.
All models with electric parking brake (EPB).
What you'd notice
Electric parking brake (EPB) warning lamp illuminated. Trouble codes stored in ABS control module fault memory: C2007, C2008.
The repair
ABS control module software fault.
Workshop instructions
Workshop procedure
- Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
- If no fault(s) found: Re-program ABS control module with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.
Data: Motorwise Workshop. Bulletin 9.
Suspension system warning message displayed in instrument panel.
All models with air suspension.
Air suspension reservoir cracked/damaged.
Workshop instructions & parts4 parts
Workshop procedure
- Access air suspension compressor pump assembly located under spare wheel.
- Inspect air suspension reservoir for cracks/damage in area indicated Fig.1267077.1 .
- If cracks/damage found: Fit new air suspension compressor pump assembly. Fit protective cover to air suspension compressor pump assembly to prevent further damage Fig.1267077.2 .
- View View more information
| Part | Part number | Qty |
|---|---|---|
| Protective cover | LR117060 | 1 |
| Air suspension compressor pump assembly | LR095836 | 1 |
| Air pipe connector | LR083989 | 1 |
| Air pipe connector | LR041295 | 1 |
Data: Motorwise Workshop. Bulletin 11.
Suspension & drivetrain
1 documented fault — symptoms, causes and workshop fixes.
Abnormal noise from front suspension under heavy braking.
All models.
Workshop instructions & parts2 parts
Workshop procedure
- Replace front suspension lower arm rear bush on both sides.
| Part | Part number | Qty |
|---|---|---|
| Front suspension lower arm rear bush | LR058161 | 2 |
| Bolt | LR034229 | 2 |
Data: Motorwise Workshop. Bulletin 5.
Clutch & gearbox
1 documented fault — symptoms, causes and workshop fixes.
Warning message 'Transmission Fault' displayed in instrument panel.
All models with 8HP70 transmission code, 2014-16.
What you'd notice
Transmission control module (TCM) in limp home mode. Trouble code stored: P0780.
The repair
Transmission control module (TCM) software fault.
Workshop instructions
Workshop procedure
- Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
- If no fault(s) found: Re-program transmission control module (TCM) with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.
Data: Motorwise Workshop. Bulletin 6.
Body & trim
1 documented fault — symptoms, causes and workshop fixes.
Wind noise from panoramic sunroof area whilst driving at high speed.
All models with panoramic sunroof.
Deformation of panoramic sunroof front weather seal.
Workshop instructions
Workshop procedure
- Fit new panoramic sunroof front weather seal.
Data: Motorwise Workshop. Bulletin 12.
Wipers & visibility
1 documented fault — symptoms, causes and workshop fixes.
Windscreen wipers intermittent operation or not working.
All models, 2012→.
What you'd notice
Indicators intermittent operation or not working.
The repair
Poor electrical connection between switch assembly and harness multi-plug.
Workshop instructions & parts1 part
Workshop procedure
- Remove windscreen wiper switch.
- Clean windscreen wiper switch harness multi-plug terminals Fig.1217605.1 .
- Lightly coat terminals with grease Fig.1217605.1 . Use specified grease.
- Refit windscreen wiper switch.
- Repeat procedure for indicator switch.
| Part | Part number | Qty |
|---|---|---|
| Electrical contact grease (Nyogel) | LR054614 | 1 |
Data: Motorwise Workshop. Bulletin 7.
Take it with you
Before you view one
Land Rover Range Rover Sport 4.4 SDV8 (2014–2020)
Each documented fault as a quick check for a viewing or test drive — tick them off as you go.
A little workshop vocabulary
Workshop terms used on this page
Definitions for the technical language used in these bulletins.
- ABS
- Anti-lock braking system — stops the wheels locking under hard braking
- Trouble Codes
- Standardised fault codes stored by the engine computer, read with a diagnostic tool
- EPB
- Electric parking brake — an electronic handbrake, operated by a switch rather than a lever
- IAT
- Intake air temperature — a sensor that measures how hot the air entering the engine is
- TC
- Turbocharger — the exhaust-driven compressor that boosts engine power
- TCM
- Transmission control module — the gearbox computer
- Air Suspension
- A system that uses air springs instead of steel coils, so ride height can be raised or lowered
- CAN Data Bus
- The car's internal network that lets control modules talk to each other
- Compressor Pump
- The pump that pressurises the air-suspension system
- Control Module
- A computer that runs one of the car's systems (engine, gearbox, brakes, body, and so on)
- Fault Memory
- The list of stored trouble codes in a control module
- Instrument Panel
- The dashboard display that shows warning lights and messages
- Intercooler
- A radiator that cools the air coming out of the turbocharger before it enters the engine
- Limp Home
- A safety mode that cuts power so you can crawl to a workshop
- Manifold Absolute Pressure
- A sensor reading of pressure in the intake — used to work out engine load
- Multi-Plug
- A multi-pin electrical connector on a wiring harness
- Re-Program
- Update the software on a control module using the manufacturer's diagnostic tool
- Trouble Code
- A standardised fault code stored by a control module, read with a diagnostic tool
- Undertray
- The plastic shield under the engine bay
- Bonnet Switch
- The switch that tells the alarm whether the bonnet is open
- Bush
- A rubber mounting that lets a suspension or body joint move without metal-to-metal contact
- Intercooler Hose
- The pipe that carries pressurised air between the turbocharger, intercooler and engine
- Lower Arm
- A suspension link that locates the wheel at the bottom of the hub
- Sleep Mode
- The low-power state control modules enter when the car is parked; if one stays awake the battery can go flat
- Splash Baffle
- A plate inside the fuel tank that stops fuel sloshing
Common questions
Using this guide.
What are the common faults with the Land Rover Range Rover Sport 4.4 SDV8?
Garages and workshops regularly encounter 14 documented faults on the Land Rover Range Rover Sport 4.4 SDV8 — four concern the engine and fuel system and four the brakes. Each fault above lists the symptoms, cause, fix and any parts needed.
Does every Land Rover Range Rover Sport 4.4 SDV8 have these faults?
No. These are patterns documented across the model by workshops, not predictions for an individual car. Where a fault applies only to certain vehicles or VIN ranges, that is listed with the fault.
Can I check for Land Rover Range Rover Sport 4.4 SDV8 faults when viewing one?
Many of them, yes — the documented symptoms are things you can see, hear or feel on a viewing or test drive. The 'Before you view one' checklist above turns each documented fault into a quick check you can tick off as you go.