Land Rover2015–2020

Range Rover Sport 3.0 SDV6: Common faults & known problems

Common faults & known problems

14 known faults documented in workshop bulletins. Of these, six concern the engine and fuel system and two the electrical and ignition. Symptoms, causes, repair steps and part numbers are shown where supplied.

Engine & fuel system

6 documented faults — symptoms, causes and workshop fixes.

Engine malfunction indicator lamp (MIL) illuminated

Overview

Affects
All models with 3.0/4.4 Diesel engines.
Fault codes
P1247

Symptoms

Loss of engine power.

Cause

Turbocharger (TC) to intercooler hose split.

Repair

  1. Check turbocharger (TC) intercooler for damage. Replace if necessary.
  2. Replace turbocharger (TC) intercooler hose.

Data: Motorwise Workshop. Bulletin 2.

Engine surges on light throttle, more noticeable at high speed

Throttle valve sticking. Fix: fit a new part.

Overview

Affects
All models with 3.0 Diesel engine.
Fault codes
P0488
Remedy
Fit new part

Symptoms

Engine malfunction indicator lamp (MIL) illuminated. Trouble code stored: P0488-72.

Repair steps

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Fit new throttle body.
  3. Carry out throttle valve calibration.

Parts

Parts listed in the bulletin
PartPart numberQty
Throttle bodyLR0494461

Data: Motorwise Workshop. Bulletin 4.

Engine coolant leak from front bumper area

Engine coolant auxiliary radiator chafed through on air intake duct due to front bumper misaligned.

Overview

Affects
All models with 306PS/306DT/508PS engine codes.

Repair steps

  1. Remove front bumper to gain access to engine coolant auxiliary radiators.
  2. Inspect engine coolant auxiliary radiators for damage and leaks. Renew engine coolant auxiliary radiators if necessary.
  3. Fit foam pads to new engine coolant auxiliary radiator.
  4. Refit front bumper. Ensure front bumper is correctly aligned.

Parts

Parts listed in the bulletin
PartPart numberQty
Engine coolant auxiliary radiatorLR062670As required
Foam padLR095560As required

Data: Motorwise Workshop. Bulletin 5.

Poor engine performance

Overview

Affects
All models with 3.0 Diesel engine, 2010→.
Remedy
Fit new part
Parts
2 parts

Cause

Intake manifold split or cracked.

Repair

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Fit new intake manifold(s) as necessary.
Parts2 parts
Parts listed in the bulletin
PartPart numberQty
Intake manifold (LH)LR0735851
Intake manifold (RH)LR0746231

Data: Motorwise Workshop. Bulletin 6.

Splashing noise heard under acceleration or braking at low speed

Lack of splash baffle in fuel tank.

Overview

Affects
All models with Diesel engines.

Repair steps

  1. Remove fuel tank.
  2. Remove fuel pump assembly from fuel tank.
  3. Fit fuel tank splash baffle.
  4. Refit components in reverse order of removal.

Parts

Parts listed in the bulletin
PartPart numberQty
Fuel tank splash baffleLR0656781
O-ringLR0009661

Data: Motorwise Workshop. Bulletin 13.

Rattling noise from underside of vehicle

Overview

Affects
All models.
Remedy
Fit new part
Parts
1 part

Cause

Sound insulation material on engine undertray loose due to failure of retaining clips.

Repair

  1. Remove and discard sound insulation material retaining clips.
  2. Fit new sound insulation material retaining nuts.
Parts1 part
Parts listed in the bulletin
PartPart numberQty
NutLR0036431

Data: Motorwise Workshop. Bulletin 14.

Electrical & ignition

2 documented faults — symptoms, causes and workshop fixes.

Intermittent self-activation of alarm system siren

Affects All models.Fit new part

Symptoms

Audible warning sounds when locking vehicle. Bonnet open warning message displayed in instrument panel.

Cause

Repair

  1. Fit new bonnet switch. Bonnet switch integral to bonnet latch.
Parts1 part
Parts listed in the bulletin
PartPart numberQty
Bonnet switchLR0543311

Data: Motorwise Workshop. Bulletin 1.

Battery discharged after standing overnight

CAN data bus gateway control module does not switch to sleep mode due to software fault. Fix: re-program with updated software.

Overview

Affects
All models, 2014-16.
Remedy
Software update

Symptoms

Clicking noise from load area when ignition switched ON. Low battery voltage warning displayed in instrument panel.

Repair steps

  1. Charge battery if necessary.
  2. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  3. If no fault(s) found: Re-program CAN data bus gateway control module with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.

Data: Motorwise Workshop. Bulletin 9.

Brakes

2 documented faults — symptoms, causes and workshop fixes.

Electric parking brake (EPB) warning message displayed in instrument panel

Overview

Affects
All models with electric parking brake (EPB).
Fault codes
C2007C2008
Remedy
Software update

Symptoms

Electric parking brake (EPB) warning lamp illuminated. Trouble codes stored in ABS control module fault memory: C2007, C2008.

Cause

ABS control module software fault.

Repair

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Re-program ABS control module with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.

Data: Motorwise Workshop. Bulletin 10.

Suspension system warning message displayed in instrument panel

Air suspension reservoir cracked/damaged. Fix: fit a new part.

Overview

Affects
All models with air suspension.
Remedy
Fit new part

Repair steps

  1. Access air suspension compressor pump assembly located under spare wheel.
  2. Inspect air suspension reservoir for cracks/damage in area indicated.
  3. If cracks/damage found: Fit new air suspension compressor pump assembly. Fit protective cover to air suspension compressor pump assembly to prevent further damage.

Parts

Parts listed in the bulletin
PartPart numberQty
Protective coverLR1170601
Air suspension compressor pump assemblyLR0958361
Air pipe connectorLR0839891
Air pipe connectorLR0412951

Data: Motorwise Workshop. Bulletin 11.

Suspension & drivetrain

1 documented fault — symptoms, causes and workshop fixes.

Abnormal noise from front suspension under heavy braking

Affects All models.

Cause

Front suspension lower arm rear bush worn.

Repair

  1. Replace front suspension lower arm rear bush on both sides.
Parts2 parts
Parts listed in the bulletin
PartPart numberQty
Front suspension lower arm rear bushLR0581612
BoltLR0342292

Data: Motorwise Workshop. Bulletin 3.

Clutch & gearbox

1 documented fault — symptoms, causes and workshop fixes.

Warning message 'Transmission Fault' displayed in instrument panel

Overview

Affects
All models with 8HP70 transmission code, 2014-16.
Fault codes
P0780
Remedy
Software update

Symptoms

Transmission control module (TCM) in limp home mode. Trouble code stored: P0780.

Cause

Transmission control module (TCM) software fault.

Repair

  1. Carry out electrical, mechanical and component tests (as applicable) to eliminate any other possible cause(s).
  2. If no fault(s) found: Re-program transmission control module (TCM) with upgraded software. Note: To carry out an effective repair a software upgrade will be required - refer to manufacturer.

Data: Motorwise Workshop. Bulletin 7.

Body & trim

1 documented fault — symptoms, causes and workshop fixes.

Wind noise from panoramic sunroof area whilst driving at high speed

Affects All models with panoramic sunroof.Fit new part

Cause

Deformation of panoramic sunroof front weather seal.

Repair

  1. Fit new panoramic sunroof front weather seal.

Data: Motorwise Workshop. Bulletin 12.

Wipers & visibility

1 documented fault — symptoms, causes and workshop fixes.

Windscreen wipers intermittent operation or not working

Poor electrical connection between switch assembly and harness multi-plug. Fix: clean and lubricate.

Overview

Affects
All models, 2012→.
Remedy
Clean & lubricate

Symptoms

Indicators intermittent operation or not working.

Repair steps

  1. Remove windscreen wiper switch.
  2. Clean windscreen wiper switch harness multi-plug terminals.
  3. Lightly coat terminals with grease Use specified grease.
  4. Refit windscreen wiper switch.
  5. Repeat procedure for indicator switch.

Parts

Parts listed in the bulletin
PartPart numberQty
Electrical contact grease (Nyogel)LR0546141

Data: Motorwise Workshop. Bulletin 8.

Glossary

Technical terms used in this guide.

MIL
Malfunction indicator lamp — the engine warning light on the dashboard
ABS
Anti-lock braking system — stops the wheels locking under hard braking
Trouble Codes
Standardised fault codes stored by the engine control module, read with a diagnostic tool
EPB
Electric parking brake — an electronic handbrake, operated by a switch rather than a lever
TC
Turbocharger — the exhaust-driven compressor that boosts engine power
TCM
Transmission control module — the electronic unit that manages the gearbox
Air Suspension
A system that uses air springs instead of steel coils, so ride height can be raised or lowered
CAN Data Bus
The car's internal network that lets control modules talk to each other
Compressor Pump
The pump that pressurises the air-suspension system
Control Module
A control unit for one of the vehicle's systems (engine, gearbox, brakes, body, and so on)
Fault Memory
The list of stored trouble codes in a control module
Instrument Panel
The dashboard display that shows warning lights and messages
Intake Manifold
The housing that distributes air into the cylinders
Intercooler
A radiator that cools the air coming out of the turbocharger before it enters the engine
Limp Home
A protective mode that limits power so the vehicle can be driven to a workshop
Multi-Plug
A multi-pin electrical connector on a wiring harness
Re-Program
Update the software on a control module using the manufacturer's diagnostic tool
Trouble Code
A standardised fault code stored by a control module, read with a diagnostic tool
Undertray
The plastic shield under the engine bay
Bonnet Switch
The switch that tells the alarm whether the bonnet is open
Bush
A rubber mounting that lets a suspension or body joint move without metal-to-metal contact
Calibration
Setting a sensor or module so its readings match the real world
Intercooler Hose
The pipe that carries pressurised air between the turbocharger, intercooler and engine
Lower Arm
A suspension link that locates the wheel at the bottom of the hub
Sleep Mode
The low-power state control modules enter when the car is parked; if one stays awake the battery can go flat
Splash Baffle
A plate inside the fuel tank that stops fuel sloshing

Frequently asked questions

What are the common faults with the Land Rover Range Rover Sport 3.0 SDV6?

This guide contains 14 workshop bulletins for the Land Rover Range Rover Sport 3.0 SDV6. Of these, six concern the engine and fuel system and two the electrical and ignition. Symptoms, causes, repair steps and part numbers are shown where supplied.

Does every Land Rover Range Rover Sport 3.0 SDV6 have these faults?

No. These are patterns documented across the model by workshops, not predictions for an individual vehicle. Where a fault applies only to certain vehicles or VIN ranges, that is listed with the fault.

Can I check for Land Rover Range Rover Sport 3.0 SDV6 faults myself?

Many of them. The documented symptoms can be seen, heard or felt during a test drive.

Related guides

Glossary term

See in the glossary →